HP 2108, 2115 manual Set the paper type

		hp psc 2100 series
paper	tips
4-by-6 inch photo	Insert the photo paper with the print-side down into the paper tray until it
paper (works only	stops. Place the long edge of the photo paper against the right side of the
with printing)	paper tray, slide the paper-width guide up against the long edge of the
	photo paper, and slide the paper-length guide in until it stops. If the photo
	paper you are using has perforated tabs, load the photo paper so that the
	tabs are closest to you.
Continuous (banner)	Continuous banner paper is also known as computer or z-fold paper.
paper	•	Before loading banner paper, remove all other paper from the paper
(works only with		tray, then remove the output tray.
printing)
		Remove the output
		tray.
		Insert the unattached
		edge of the paper into
		the paper tray.
	•	If you use non-HP banner paper, use 20-lb. paper and fan the paper
		before loading it.
	•	Verify that the stack of banner paper contains at least five pages in the
		stack.
	•	Carefully tear off the perforated edge strips from both sides of the
		paper stack, if any, and unfold and refold the paper to make sure the
		pages do not stick together.
	•	Put the paper in the paper tray so that the unattached edge is at the
		top of the stack. Insert the first edge into the paper tray until it stops, as
		shown in the illustration above.

set the paper type

If you want to use a different type of paper, such as photo paper, transparency film, t-shirt transfer paper, or brochures, simply load that paper in the paper tray. You should then change the paper type settings to ensure the best print quality.

HP recommends paper type settings according to the type of paper you’re using.

This setting refers to copy options only. If you want to set the paper type for printing, set the properties from the Print dialog box.

1Press Copy Options until Paper Type appears, then press Enter.

2Press until the appropriate paper type appears.

set the paper type 13