HP C7185, C7180 manual Remove all tape and lift display, Locate components

Page 1

Wireless or wired network users: you must follow the instructions in this setup guide to be successful adding the HP All-in-One to your network.

USB cable users: Do not connect the USB cable until step A2.

2	Remove all tape and lift display

a	b	a Remove all tape from the front, back,
		a Remove all tape from the front, back,

and both sides of the device. Remove the protective ﬁlm from the color graphics display.

b Lift the control panel.

3 Locate components

This CD may be included for some languages where help is not available through the software.

HP Photosmart C7100 All-in-One series

Basics Guide

power cord

control panel faceplate (may be pre-attached)

phone cord

ink cartridges

USB cable*

Ethernet cable*

*May need to be purchased separately.

The contents of your box may differ.

HP Photosmart C7100 All-in-One series Setup Guide

Image 1

Contents Locate components Remove all tape and lift displayLoad plain paper into the bottom tray If not attachedOpen the access door Connect the power cordConnect the supplied phone cord Press the On buttonInsert all six ink cartridges Lift latches inside of the deviceConnect the HP All-in-One Close the access door and follow the promptsWireless Network Ethernet Wired NetworkChoose ONE connection type A, B or C USB Connection Do not connect yetSection a USB Connection A1 Choose the correct CDA2 Connect the USB cable A3 Congratulations! Go to of this Setup GuideConnect the Ethernet cable Section B Ethernet wired networkB2 Choose the correct CD B3 Congratulations! Go to of this Setup GuideC2 Establish the wireless connection C1 Choose ONE wireless network option a or BSection C Wireless Network Option a SecureEasySetupOption B Typical Wireless Setup Recommended C3 Insert the correct CD C4 Congratulations! Go to of this Setup GuideCongratulations! Go to of this Setup Guide Install software on additional computersTroubleshooting Network Troubleshooting Print a 4 x 6 inch photo