HP C7185, C7180 manual Close the access door and follow the prompts, Connect the HP All-in-One

Page 5

13 Close the access door and follow the prompts

a	a After you close the access door, a prompt appears
	to load plain white paper. Make sure paper is
	loaded, and then press OK to start the process.
	The device initializes the ink cartridges and aligns
	the printer. This takes approximately 5 minutes.

CAUTION: Do not disconnect or turn off the

HP All-in-One during this time. You may hear the device making noises.

bAfter the alignment page is printed, alignment is complete. Check the display for status, then press OK. Recycle or discard the alignment page.

Continue to the next page for instructions on connecting your HP All-in-One to your computer or to your network.

HP All-in-One • 5

Image 5

Contents Locate components Remove all tape and lift displayLoad plain paper into the bottom tray If not attachedOpen the access door Connect the power cordConnect the supplied phone cord Press the On buttonInsert all six ink cartridges Lift latches inside of the deviceConnect the HP All-in-One Close the access door and follow the promptsWireless Network Ethernet Wired NetworkChoose ONE connection type A, B or C USB Connection Do not connect yetSection a USB Connection A1 Choose the correct CDA2 Connect the USB cable A3 Congratulations! Go to of this Setup GuideConnect the Ethernet cable Section B Ethernet wired networkB2 Choose the correct CD B3 Congratulations! Go to of this Setup GuideC2 Establish the wireless connection C1 Choose ONE wireless network option a or BSection C Wireless Network Option a SecureEasySetupOption B Typical Wireless Setup Recommended C3 Insert the correct CD C4 Congratulations! Go to of this Setup GuideTroubleshooting Install software on additional computersCongratulations! Go to of this Setup Guide Network Troubleshooting Print a 4 x 6 inch photo