HP C7185, C7180 manual Connect the Ethernet cable, Section B Ethernet wired network

Page 9

Section B: Ethernet (wired) network

Connect the Ethernet cable

aLocate the Ethernet cable that you may have purchased separately.

b Remove the yellow plug from the back of the device.

c Connect one end of the Ethernet cable to the Ethernet port on the back of the device.

d Connect the other end of the Ethernet cable to the router.

IMPORTANT: Your computer and the HP All-in-One must be on the same active, working network.

If you are using a DSL or cable modem, make sure you do not connect the Ethernet cable from the HP All-in-One to the cable modem. Connect it to the router only.

HP All-in-One • 9

Image 9

Contents Locate components Remove all tape and lift displayLoad plain paper into the bottom tray If not attachedOpen the access door Connect the power cordConnect the supplied phone cord Press the On buttonInsert all six ink cartridges Lift latches inside of the deviceConnect the HP All-in-One Close the access door and follow the promptsWireless Network Ethernet Wired NetworkChoose ONE connection type A, B or C USB Connection Do not connect yetSection a USB Connection A1 Choose the correct CDA2 Connect the USB cable A3 Congratulations! Go to of this Setup GuideConnect the Ethernet cable Section B Ethernet wired networkB2 Choose the correct CD B3 Congratulations! Go to of this Setup GuideC2 Establish the wireless connection C1 Choose ONE wireless network option a or BSection C Wireless Network Option a SecureEasySetupOption B Typical Wireless Setup Recommended C3 Insert the correct CD C4 Congratulations! Go to of this Setup GuideInstall software on additional computers Congratulations! Go to of this Setup GuideTroubleshooting Network Troubleshooting Print a 4 x 6 inch photo