HP C7180, C7185 manual A2 Connect the USB cable, A3 Congratulations! Go to of this Setup Guide

Page 8

A2 Connect the USB cable

Windows Users:

aFollow the onscreen instructions until you see the prompt to connect the USB cable. (This may take several minutes.)

Once the prompt appears, connect the USB cable to the port on the back of the HP All-in-One, and then to any USB port on your computer.

Mac Users:

aConnect the USB cable from your computer to the USB port on the back of the device.

b Double-click the HP All-in-One Installer icon.

c Make sure you complete all screens, including the Setup Assistant.

bFollow the onscreen instructions to complete the software installation.

A3 Congratulations! Go to Step 18 of this Setup Guide

8 • HP All-in-One

Image 8

Contents Remove all tape and lift display Locate componentsIf not attached Load plain paper into the bottom trayConnect the power cord Open the access doorConnect the supplied phone cord Press the On buttonLift latches inside of the device Insert all six ink cartridgesClose the access door and follow the prompts Connect the HP All-in-OneEthernet Wired Network Wireless NetworkChoose ONE connection type A, B or C USB Connection Do not connect yetA1 Choose the correct CD Section a USB ConnectionA3 Congratulations! Go to of this Setup Guide A2 Connect the USB cableSection B Ethernet wired network Connect the Ethernet cableB3 Congratulations! Go to of this Setup Guide B2 Choose the correct CDC1 Choose ONE wireless network option a or B C2 Establish the wireless connectionSection C Wireless Network Option a SecureEasySetupOption B Typical Wireless Setup Recommended C4 Congratulations! Go to of this Setup Guide C3 Insert the correct CDTroubleshooting Install software on additional computersCongratulations! Go to of this Setup Guide Network Troubleshooting Print a 4 x 6 inch photo