REMOVING FRONT SCREEN
1)Lift the front screen slightly up (Fig. 7A) and then tilt the bottom of the screen inward and downward (Fig. 2B). 2) Lean the top of the screen toward you slightly (Fig. 7B) and then proceed to carefully bring the screen straight back (Fig. 7C). NOTE: To reinstall the front screen, reverse steps 1 & 2.
FIG 7A | FIG 7B | FIG 7C |
LOG ASSEMBLY
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
1.Installtherearlog(#2)ontherearsetoflocators. Visuallychecktoverifythelogissecurelyplacedonthelocators.
2.Install the front log (#1) on the front locators. Visually check to verify the log is securely placed on the locators.
3.Install the left and right cross twigs as illustrated, on the locator pins provided in the front and rear logs. Holes provided in the bottom of the cross twigs should allow them to seat completely over these pins.
#2
#1
WARNING: Failure to position the parts in accordance with these dia- grams or failure to use only parts specificallyapprovedwiththisheater may result in property damage or personalinjury.
FIGURE 8. Log Set Assembly
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly situated in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater.
FRONT SCREEN
Thefrontscreenmustbeinplaceatalltimeswhentheapplianceisoperating.Donotobstructthescreenedopenings oftheheater.
10