THE FIRST FIRES
The fresh paint on your stove needs to be cured to preserve its quality. Once the fuel charge is properly ignited, only burn small fires in your stove for the first four hours of operation. Never open the air control more than necessary to achieve a medium burn rate.
Make sure that there’s enough air circulation while curing the stove. The odors could be smelled during the 3 or 4 first fires. Never start your stove outside. You will not be able to see if you are over heating.
IGNITION
After making sure that the stove air intake controls are fully open (completely
Before igniting the paper and kindling wood, it is recommended that you warm up the chimney. This is done in order to avoid back draft problems often due to negative pressure in the house. If such is the case, open a window slightly near the stove and twist together a few sheets of newspaper into a torch. Light up this paper torch and hold it as close as possible to the mouth of the pipe inside the combustion chamber to warm up the chimney. Once the updraft movement is initiated, you are ready to ignite the stove by lighting the paper and kindling wood inside the combustion chamber.
When you have achieved a good bed of hot embers, we recommend the following burn procedures:
2000
|
| Primary Air Settings |
| Electric Blower Speed Setting (Variable) |
| ||
| (Slide Damper is located in center of stove under hearth plate) |
| (Blower is on High when turned “ON”, Rotate clock- |
| |||
| (Damper Adjustment: Pulling out on damper increases air) |
| wise until stop for “LOW”.) |
| |||
|
|
|
|
|
|
|
|
| Burn Rate |
| Adjust Damper from fully closed |
| Burn Time | Blower Speed |
|
| Low |
| 1/4” |
| @ 30 minutes | Low |
|
| Medium - Low |
| 3/8” |
| @ 30 minutes | Low |
|
| Medium - High |
| 1/2” |
| @ 30 minutes | Low |
|
| High |
| approx. 3” |
| all minutes | High |
|
|
| 2500 |
|
|
| ||
| Burn Rate |
| Adjust Damper from fully closed |
| Burn Time | Blower Speed |
|
| Low |
| 1/32” |
| @ 30 minutes | Low |
|
| Medium - Low |
| 1/16” |
| @ 30 minutes | Low |
|
| Medium - High |
| 5/16” |
| @ 30 minutes | Low |
|
| High |
| approx. 3” |
| all minutes | High |
|
HEATING
Controlled combustion is the most efficient technique for wood heating because it enables you to select the type of combustion you want for each given situation. The wood will burn slowly if the wood stove air intake control is adjusted to reduce the oxygen supply in the combustion chamber to a minimum. On the other hand, wood will burn quickly if the air control is adjusted to admit a larger quantity of oxygen in the combustion chamber. The air intake control on your stove is very simple. If you pull on it out completely towards you, it is fully open. If you push on it until it stops the combustion air is reduced to a minimum. Real operating conditions may give very different results than those obtained during testing according to the species of wood used, its moisture content, the size and density of the pieces, the length of the chimney, altitude and outside temperature.
Ussc | 15 |