Delete Sensors in Memory, Walk-Around Learn

Delete Sensors in Memory

This function is used to delete all sensor data stored in the Tool memory.

Walk-Around Learn

Walk-Around Learn Procedure

When the tires are rotated or replaced on a vehicle with a tire pressure monitoring system, the vehicle must re-learn the position of each tire. The Walk-Around Learn procedure is used to activate each sensor in its new location, store the sensor information, and download to the vehicle’s tire pressure sensor receiver.

The unit will learn and store the location of each sensor as the user walks around the vehicle in a U- shaped pattern, starting at the left side (looking forward) front-most tire location. If this is a dual tire axle, start with the inner tire location. The new location information (tire IDs) for each sensor collected is then uploaded to the receiver in the vehicle.

Perform the following steps:

1.Power up the vehicle’s tire pressure sensor receiver (see vehicle's service information for specific details).

2.Press and hold the Setup button until a list of menu items appear.

3. Select the Walk-Around Learn icon.

4.Select the number of tires on the vehicle.

5.Activate each of the vehicle's wheel sensors in the proper order (counter-clockwise and inner tire to outer tire, starting from the front left tire). See the "Walk-Around Learn" card included with the

Tool.

6.Hold the SmarTire® system Tool’s antenna against the tire’s upper sidewall in line with the valve

stem. Press the Learn button. The Tool is able to receive signals from an inner tire on a dual tire configuration as well. Just hold the Tool in line with the circumferential position of the valve stem of the inner wheel, as indicated in Figure 7.

Figure 7

7.Once the Tool has learned the tire sensor ID for the given position, it automatically switches to the next tire position. Repeat until all the tires have been learned.

Page 11