BENDIX BW2809 manual Hardware Specifications, Electrical Specifications, Power

Page 22

Figure 14 Sensor not found

Specifications

Hardware Specifications

General Specifications

∙Handheld 125 kHz LF generator.

(To provide activation of SmarTire® sensors)

∙Requires replaceable “C” cell batteries (either Alkaline or NiMH)

The battery compartment is in the rear of the unit.

Battery life expectancy is approximately 300+ activations.

A Tool battery level indicator is located in the lower left hand corner of the main display screen.

Electrical Specifications

Communication Interfaces

∙RS-232 (diagnostic interface port): Used for updating the Tool and for communicating with J1939 receiver.

System Resources

∙100 sensor memory space.

Power

PARAMETERS	CONDITION	VALUE

		Three (3) “C” Cell
Supply Voltage	(Alkaline or NiMH)	Batteries, or equivalent
		NiMH rechargeable.

Page 22

Image 22

Contents SmarTire Tpms Maintenance Hand Tool Revision Page Table of Contents FCC Compliance Label User Interface IllustrationTesting Tire Sensors IntroductionInitiate Function Setup MenuMain Menu Learn FunctionMain Menu Icon Legend Main Menu DetailsExample Display Set-up Menu Icon Legend SoftwareSet-up Menu Icon Explanations Software UpdateMaintenance Tool Software Update Description RequiredPsi/BAR/kPa/C/F Measurement Units Stored Sensor Information RetrievalDelete Sensors in Memory Walk-Around Learn ProcedureWalk-Around Learn Page Ambient Pressure Sensor Learn Ambient Pressure CompensationTrailer Cold Inflation Pressures CIP ECU Hand Tool Remove LED Insert Harness Page Page ECU Hand Tool Remove LED Insert Harness Return Sensor LearnExecution Icons AlertTroubleshooting Examples Sensor with low batteryElectrical Specifications SpecificationsHardware Specifications PowerReceiver Specifications Radio Frequency SpecificationsMechanical Specifications LF Transmitter SpecificationsTroubleshooting Problem Potential SolutionTrademarks