ASRock 960GM-S3 FX manual Multiplier/Voltage Change, CPU Frequency Multiplier, Processor Voltage

Multiplier/Voltage Change

This item is set to [Auto] by default. If it is set to [Manual], you may adjust the value of Processor Frequency and Processor Voltage. However, it is recommended to keep the default value for system stability.

BIOS SETUP UTILITY

Main OC Tweaker Advanced H/W Monitor Boot Security Exit

EZ Overclocking

Load Optimized CPU OC Setting	[Press Enter]
Load Optimized mGPU OC Setting	[Press Enter]
CPU Configuration
Overclock Mode	[Auto]
CPU Frequency (MHz)	[200]
PCIE Frequency (MHz)	[100]
Spread Spectrum	[Auto]
	[Enabled]
Boot Failure Guard
	[3]
Boot Failure Guard Count
Advanced Clock Calibration	[Disabled]
AMD Turbo Core Technology	[Auto]
AMD IO C-State Support	[Enabled]
CPU Active Core Control	[Disabled]
Processor Maximum Frequency	x13.5 2700 MHZ
North Bridge Maximum Frequency	x10.0 2000 MHz
Processor Maximum Voltage	1.325 V
Multiplier/Voltage Change	[Manual]

Overclocking may cause damage to your CPU and motherboard.

It should be done at your own risk and expense.

	Select Screen
	Select Item
Enter	Go to Sub Screen
F1	General Help
F9	Load Defaults
F10	Save and Exit
ESC	Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

CPU Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

Processor Voltage

It allows you to adjust the value of processor voltage. However, for safety and system stability, it is not recommended to adjust the value of this item.

NB Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

HT Bus Speed

This feature allows you selecting Hyper-Transport bus speed. Configuration options: [Auto], [x1 200MHz] to [x8 1600MHz].

HT Bus Width

This feature allows you selecting Hyper-Transport bus width. Configuraion options: [Auto], [8 Bit] and [16 Bit].

Memory Configuration

Memory Clock

This item can be set by the code using [Auto]. You can set one of the standard values as listed: [400MHz DDR3_800], [533MHz DDR3_1066],

[667MHz DDR3_1333] and [800MHz DDR3_1600].

DRAM Voltage

Use this to select DRAM voltage. Configuration options: [Auto], [1.30V] to [2.05V]. The default value is [Auto].

38