ASRock A75M-ITX manual ATX 12V Power Connector Please connect an ATX

Page 29

ATX 12V Power Connector

Please connect an ATX 12V

(4-pin ATX12V1)

power supply to this connector.

(see p.12 No. 21)

 

 

 

Serial port Header

This COM1 header supports a

(9-pin COM1)

serial port module.

(see p.12 No. 5)

 

HDMI_SPDIF Header

HDMI_SPDIF header, providing

(2-pin HDMI_SPDIF1)

SPDIF audio output to HDMI

(see p.12 No. 22)

VGA card, allows the system to

 

connect HDMI Digital TV/

 

projector/LCD devices. Please

 

connect the HDMI_SPDIF

 

connector of HDMI VGA card to

 

this header.

29

Image 29
Contents A75M-ITX Disclaimer Copyright NoticeContents Uefi Setup Utility Introduction Package ContentsSpecifications Bios Feature ConnectorUnique Feature Rear Panel I/OCertifications HardwareMonitor Page Page Page ATXPWR1 Motherboard LayoutTable for Audio Output Connection I/O PanelLAN Port LED Indications Page Pre-installation Precautions InstallationInstallation of CPU Fan and Heatsink CPU InstallationInstalling a Dimm Installation of Memory Modules DimmExpansion Slot PCI Express Slot Installing an expansion cardWhat does an AMD Dual Graphics system include? AMD Dual Graphics Operation GuideEnjoy the benefit of AMD Dual Graphics AMD Vision Engine Control Center Dual Monitor Feature Dual Monitor and Surround Display FeaturesFor Windows XP / XP 64-bit OS Surround Display FeatureHdcp Function What is HDCP?For Windows 7 / 7 64-bit / VistaTM / VistaTM 64-bit OS CIR sensors in different angles ASRock Smart Remote Installation GuideDescription Jumpers SetupSerial ATA3 Connectors Onboard Headers and ConnectorsFront Panel Audio Header Supply to this connector CPU Fan ConnectorsATX Power Connector ATX 12V Power Connector Please connect an ATX What is Hot Plug Function? Serial ATA3 SATA3 Hard Disks InstallationWhat is Hot Swap Function? Hot Plug and Hot Swap Functions for SATA3 HDDsPoints of attention, before you process the Hot Plug SATA3 HDD Hot Plug Feature and Operation GuideHow to Hot Plug a SATA3 HDD Set up Uefi Driver Installation GuideInstalling Windows XP / XP 64-bit With RAID Functions \ RAID Installation Guide Make a SATA3 Driver Diskette Use RAID Installation Guide to set RAID configurationInstalling Windows XP / XP 64-bit Without RAID Functions Page Uefi Menu Bar Main Screen Navigation KeysTo jump to the Exit Screen or exit the current screen System Time HourMinuteSecondOC Tweaker Screen Dram Timing Control Power Down Enable Dram Configuration Dram FrequencyMultiplier/Voltage Change CPU Frequency MultiplierCommand Rate CR RAS# to CAS# Delay tRCDWrite Recovery Time tWR RAS to RAS Delay tRRDSB Voltage Would you like to save current setting user defaults?CPU Load-Line Calibration Instant Flash Advanced ScreenCore C6 Mode CPU ConfigurationPackage C6 Mode Cool ‘n’ QuietPrimary Graphics Adapter North Bridge ConfigurationShare Memory Onboard Hdmi HD AudioSouth Bridge Configuration Sata Mode Storage ConfigurationSata IDE Combined Mode Sata ControllerSerial Port Address Super IO ConfigurationSerial Port Acpi Configuration Acpi Hpet table USB 2.0 Controller USB ConfigurationUSB 3.0 Controller Legacy USB SupportHardware Health Event Monitoring Screen CPU Fan 1 & 2 SettingChassis Fan 1 Setting Boot Screen Security Screen Exit Screen Support CD Information Install Operating SystemRunning The Support CD Drivers MenuInstalling OS on a HDD Larger Than 2TB
Related manuals
Manual 157 pages 40.08 Kb