ASRock 990FX Extreme4 manual Installing Windows XP / XP 64-bit Without RAID Functions

2.17 Installing Windows® 7 / 7 64-bit / VistaTM /

VistaTM 64-bit / XP / XP 64-bit Without RAID Functions

If you want to install Windows® 7 / 7 64-bit / VistaTM / VistaTM 64-bit / XP / XP 64-bit OS on your SATA3 HDDs without RAID functions, please follow below procedures according to the OS you install.

2.17.1 Installing Windows® XP / XP 64-bit Without RAID Functions

If you want to install Windows® XP / XP 64-bit on your SATA3 HDDs without RAID functions, please follow below steps.

Using SATA3 HDDs with NCQ and Hot Plug functions (AHCI mode)

STEP 1: Set up UEFI.

A. Enter UEFI SETUP UTILITY Advanced screen Storage Configuration. B. Set the option “SATA Mode” to [AHCI]. (For SATA3_1 to SATA3_6 ports.)

Set the option “Marvell SATA3 Operation Mode” to [AHCI]. (For SATA3_7 and SATA3_8 ports.)

STEP 2: Make a SATA3 Driver Diskette.

Make a SATA3 driver diskette by following section 2.16.1 step 2 on page 45.

STEP 3: Install Windows® XP / XP 64-bit OS on your system.

You can start to install Windows® XP / XP 64-bit OS on your system. At the begin- ning of Windows® setup, press F6 to install a third-party AHCI driver. When prompt- ed, insert the SATA3 driver diskette containing the AMD AHCI driver. After reading the floppy disk, the driver will be presented. Select the driver to install according to the OS you install.

Using SATA3 HDDs without NCQ and Hot Plug functions (IDE mode)

STEP 1: Set up UEFI.

A. Enter UEFI SETUP UTILITY Advanced screen Storage Configuration. B. Set the option “SATA Mode” to [IDE]. (For SATA3_1 to SATA3_6 ports.)

Set the option “Marvell SATA3 Operation Mode” to [IDE]. (For SATA3_7 and SATA3_8 ports.)

STEP 2: Install Windows® XP / XP 64-bit OS on your system.

47