Panasonic SC-BTT490 owner manual Messages, Radio, On the television

Radio

Distorted sound or noise is heard.

¾Adjust the position of the antenna.

A beat sound is heard.

¾Try to keep a certain amount of distance between the antenna and the TV.

Stations cannot be selected.

1Press [RADIO] to select “FM”.

2 Press and hold [RADIO].

After a few seconds the display changes to show the current lowest frequency (87.9 MHz). Continue to hold the button down. The lowest frequency changes (87.5 MHz) and the step is changed.

Noise is excessive.

¾Change the audio to be output as monaural.

1 Press and hold [jAUDIO].

2 Press [jAUDIO] to select “MONO”. The sound becomes monaural.

≥To cancel, press the button again or change

the frequency.

In normal circumstances, select “AUTO STEREO”

Network

I can’t connect to the network.

¾Confirm the network connection and settings. (> 17, 18, 38)

¾Check the operating instructions for each device and connect accordingly.

When using wireless LAN connection, video from the DLNA Certified media server is not played back or video frames are dropped during playback.

¾Higher transfer rate router such as 802.11n (2.4 GHz) wireless router may solve the problem. If you use 802.11n (2.4 GHz) wireless router, it is necessary to set the encryption type to “AES”.

Simultaneous use with a microwave, cordless telephone etc. at 2.4 GHz may result in connection interruptions or other problems.

¾On the “Wireless Settings” screen (> 38), the continuous lighting of at least 4 “Reception” indicators is the target for a stable connection. If 3 or fewer indicators are lit or the connection is being interrupted, change the position or angle of your wireless router and see if the connection state improves. If there is no improvement, connect to a wired network and perform the “Easy Network Setting” (> 18) again.

Messages

The following messages or service numbers appear on the television or unit’s display.

On the television

Cannot play.

¾You inserted an incompatible disc (Discs recorded in PAL video, etc.).

Cannot display on this unit.

¾You tried to play a non-compatible image.

¾Confirm “SD” on the unit’s display is not displayed and re-insert the card.

No disc inserted.

¾The disc may be upside down.

$This operation is not available.

¾Some operations are unsupported by the unit. For example;

–BD-Video: During playback, reverse slow-motion or reverse frame-by-frame is not possible.

IP address is not set.

¾The “IP Address” in “IP Address/DNS Settings” is “---. ---. ---. ---”. Set the “IP Address”, “Subnet Mask”, and “Default Gateway”. (Select the automatic address acquisition if necessary.)

The current wireless network security setting is weak. It is recommended to change to a stronger security setting.

¾Authentication type for the wireless LAN is set to “Open system”, or the encryption type is set to “No encryption”. It is recommended to encrypt for safety reasons. For details, refer to the instructions of the wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices.

No Video

¾Depending on the connected iPod/iPhone, video menu may not be available on the TV. Select “ALL” on the unit’s display and operate video playback from your iPod/iPhone menu. (> 26)

Reference

VQT3X49 47