ASRock p4fsb1333-650 manual Installation of CPU Fan and Heatsink

Page 15

2.4Installation of CPU Fan and Heatsink

This motherboard is equipped with 775-Pin socket that supports Intel 775-LAND CPU. Please adopt the type of heatsink and cooling fan compliant with Intel 775-LAND CPU to dissipate heat. Before you installed the heatsink, you need to spray thermal interface material between the CPU and the heatsink to improve heat dissipation. Ensure that the CPU and the heatsink are securely fastened and in good contact with each other. Then connect the CPU fan to the CPU_FAN connector (CPU_FAN1, see page 10, No. 3).

For proper installation, please kindly refer to the instruction manuals of your CPU fan and heatsink.

Below is an example to illustrate the installation of the heatsink for 775-LAND CPU. Step 1. Apply thermal interface material onto center

of IHS on the socket surface.

Step 2. Place the heatsink onto the socket. Ensure fan cables are oriented on side closest to the CPU fan connector on the motherboard (CPU_FAN1, see page 10, No. 3).

Step 3. Align fasteners with the motherboard throughholes.

Step 4. Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock. Repeat with remaining fasteners.

If you press down the fasteners without rotating them clockwise, the heatsink cannot be secured on the motherboard.

Step 5. Connect fan header with the CPU fan connector on the motherboard.

Step 6. Secure excess cable with tie-wrap to ensure cable does not interfere with fan operation or contact other components.

1 5

Image 15
Contents P4FSB1333-650 Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Support CD ConnectorBios Feature See CautionDDRII533*, DDRII667 VGA 22.9cm 9.0 Motherboard LayoutTable for Audio Output Connection HD 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Land CPU Installation of CPU Fan and Heatsink Installing a Dimm Installation of Memory Modules DimmExpansion Slots PCI, Hdmr and PCI Express Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header Serial port Header Western Digital Sataii Hard Disk Setup GuideDriver Installation Guide Hdmr Card and Driver InstallationUntied Overclocking Technology Bios Menu Bar Navigation Keys Main ScreenAdvanced Screen CPU Configuration CPU Thermal Throttling Enhance Halt StateMax Cpuid Value Limit Intel R Virtualization techChipset Configuration Dram RAS# Activate to Precharge Internal Graphics Mode SelectDvmt Mode Select Dram RAS# PrechargePCI Fix Function Front PanelCD-In OnBoard LanAcpi Configuration ATA/IDE Configuration Enhanced IDE ConfigurationATA/IDE Configuration IDE Device ConfigurationBlock Multi-Sector Transfer LBA/Large ModePIO Mode DMA ModeBit Data Transfer PCIPnP ConfigurationPCI Latency Timer A.R.TSerial Port Address Floppy ConfigurationSuper IO Configuration OnBoard Floppy ControllerUSB Configuration Tolerance C Target CPU Temperature CHardware Health Event Monitoring Screen CPU Quiet FanBoot Up Num-Lock Boot ScreenBoot Settings Configuration Boot From Onboard LANMain Advanced Monitor Boot Change Supervisor PasswordSecurity Screen Discard Changes and Exit Load Optimal DefaultsExit Screen Save Changes and ExitDrivers Menu Install Operating SystemSupport CD Information Running The Support CD