ASRock ConRoe865PE manual Boot Device Priority, Security Screen, 1st Boot Device 1st Floppy Drive

Page 37

3.5.2 Boot Device Priority

In this section, you may specify the boot sequence from the available devices in your system.

 

BIOS SETUP UTILITY

 

 

 

Boot

 

 

Boot Device Priority

 

Specifies the boot

 

 

sequence from the

1st Boot Device

[1st FLOPPY DRIVE]

available devices.

 

 

2nd Boot Device

[HDD: PM-MAXTOR 6L08]

A device enclosed in

3rd Boot Device

[CD / DVD]

parenthesis has been

 

 

 

 

disabled in the

 

 

corresponding type

 

 

menu.

 

 

 

 

Select Screen

 

 

 

Select Item

 

 

+ -

Change Option

 

 

F1

General Help

 

 

F9

Load Defaults

 

 

F10

Save and Exit

 

 

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Likewise, you may also specify the boot sequence from the available devices for the hard disk drives, the removable drives, and the CD/DVD drives.

3.6 Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password

: Not Installed

User Password

: Not Installed

Change Supervisor Password

Change User Password

Clear User Password

Install or Change the password.

 

Select Screen

 

Select Item

Enter

Change

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

3 7

Image 37
Contents ConRoe865PE Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications See Caution Bios Feature ConnectorSupport CD HardwarePage 22.9cm 9.0 Motherboard LayoutTable for Audio Output Connection ASRock 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Dual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI and AGP Slots Installing an expansion cardJumper Setting Description Jumpers SetupIDE2 Onboard Headers and ConnectorsUSB 2.0 Header Chassis Speaker Header Driver Installation Guide Serial ATA Sata Hard Disks InstallationUntied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysAdvanced Screen Boot Failure Guard CPU ConfigurationCPU Host Frequency Spread SpectrumRatio Actual Value Ratio Cmos SettingEnhance Halt State Max Cpuid Value LimitChipset Configuration Acpi Configuration RTC Alarm Power On IDE ConfigurationOnBoard IDE Operate Mode Combined Mode OptionLBA/Large Mode IDE Device ConfigurationPCIPnP Configuration Super IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionUSB Controller Enabled USB ConfigurationUSB Controller USB 2.0 SupportHardware Health Event Monitoring Screen Target CPU Temperature CCPU Quiet Fan Tolerance CBoot Settings Configuration Boot ScreenBoot From Network Boot Up Num-Lock1st Boot Device 1st Floppy Drive Boot Device PriorityMain Advanced Monitor Boot Change Supervisor PasswordExit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitLGA 775 CPU Installation Live Demo Program Install Operating SystemSupport CD Information Running The Support CD