ASRock ConRoe865PE manual USB Configuration, USB Controller, USB 2.0 Support, Legacy USB Support

Page 34

3.3.8 USB Configuration

 

BIOS SETUP UTILITY

 

 

Advanced

 

 

 

USB Configuration

 

To enable or disable

 

 

the onboard USB

USB Controller

[Enabled]

controllers.

USB 2.0 Support

[Enabled]

 

 

Legacy USB Support

[Disabled]

 

 

 

 

 

Select Screen

 

 

 

Select Item

 

 

+-

Change Option

 

 

F1

General Help

 

 

F9

Load Defaults

 

 

F10

Save and Exit

 

 

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

USB Controller

Use this item to enable or disable the use of USB controller.

USB 2.0 Support

Use this item to enable or disable the USB 2.0 support.

Legacy USB Support

Use this item to enable or disable the support to emulate legacy I/O devices such as mouse, keyboard,... etc. Or you may select [Auto] so that the system will start to auto-detect; if there is no USB device connected, “Auto” option will disable the legacy USB support.

3 4

Image 34
Contents ConRoe865PE Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Support CD ConnectorSee Caution Bios Feature HardwarePage Motherboard Layout 22.9cm 9.0ASRock 8CH I/O Table for Audio Output ConnectionPre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI and AGP SlotsJumpers Setup Jumper Setting DescriptionOnboard Headers and Connectors IDE2USB 2.0 Header Chassis Speaker Header Driver Installation Guide Serial ATA Sata Hard Disks InstallationUntied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Host Frequency CPU ConfigurationBoot Failure Guard Spread SpectrumEnhance Halt State Ratio Cmos SettingRatio Actual Value Max Cpuid Value LimitChipset Configuration Acpi Configuration OnBoard IDE Operate Mode IDE ConfigurationRTC Alarm Power On Combined Mode OptionIDE Device Configuration LBA/Large ModePCIPnP Configuration OnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressParallel Port Address Parallel Port ModeECP Mode DMA Channel EPP VersionUSB Controller USB ConfigurationUSB Controller Enabled USB 2.0 SupportCPU Quiet Fan Target CPU Temperature CHardware Health Event Monitoring Screen Tolerance CBoot From Network Boot ScreenBoot Settings Configuration Boot Up Num-LockMain Advanced Monitor Boot Boot Device Priority1st Boot Device 1st Floppy Drive Change Supervisor PasswordSave Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitSupport CD Information Install Operating SystemLGA 775 CPU Installation Live Demo Program Running The Support CD