Lorex 27[sy] LED monitor manual Using the Vesa Mount Holes

Page 20

Using the VESA Mount Holes

6. Using the VESA Mount Holes

This monitor features mounting holes for a 100mm x 100mm VESA mount and an independent stand. This allows you to mount a Lorex VESA-mountable DVR to the back of the monitor or to mount the monitor to a wall or ceiling using a compatible mounting bracket (not included).

NOTE: VESA mounting bracket and VESA mount screws are not included with the monitor. If you purchase a separate mounting bracket for wall or ceiling mounting, check the documentation for your mounting bracket for installation instructions.

To mount your DVR to the back of the monitor using the VESA mount holes:

1Disconnect all cables from the DVR and monitor.

2Insert the VESA mount screws into the two top VESA mount holes on the monitor. Make sure the screws are only 3/4 of the way in; this will allow sufficient clearance to hang the DVR.

3With the front panel of the DVR facing up, align two of the VESA mount holes on the DVR and slide down into place.

VESA mount screws inserted

Example of VESA mount holes on Edge Series DVR

DVR mounted to monitor

8

Page 19 Page 21
Image 20
Page 19 Page 21
Contents TFT LED Monitor Risk of Electric Shock Do not Open Need HELP? ¿NECESITA AYUDA? Before YOU Start Avant DE Antes DE Commencer Empezar Important Safeguards Service Product Information Viii Table of Contents Page Getting Started System comes with the following componentsInstalling the Monitor Stand To install the monitor standConnecting the Monitor Connect to DVR Using VGA Monitor Overview Using the Menu PictureTracking Using the Vesa Mount Holes Maintenance Technical SpecificationsPage Page Expand and Customize Your System
Top Page Image Contents