Teka NF1650 manual Installation Requirements, Connection to the Cold Mains

Page 11

Installation Requirements

 

In order to operate the automatic ice

 

maker/dispenser and chilled water dispenser,

 

your appliance needs to be plumbed into the

 

cold mains water supply in your house via a

 

standard 1/2 “ valve fitting. In case this valve

 

is not present or in case you are not sure,

1

consult a qualified plumber.

2

 

* First of all, make sure that the parts on the

 

side are shipped with the device.

 

1. 5-meter long water pipe (1/4 inch in

 

diameter)

 

2. Cold mains water valve with mesh filter

 

(Tap Adapter)

3

3. 3 pieces of pipe clips (In case required to

 

secure the water pipe)

 

4. Water Filter to be fitted to the bracket

5

inside the fridge compartment.

4

5. Nut for connection of the water pipe to the

 

rear of the appliance

 

Connection to the Cold Mains

 

Please follow the instructions below.

 

MAKE SURE THAT STANDARD 1/2”

Water Tube

VALVE FITTING FED BY COLD MAINS

 

WATER SUPPLY IS AVAILABLE AND

 

IS TURNED OFF FULLY.

 

Connection of the Water Pipe to the

 

Refrigerator

Water Tube

1. After assembling the nut on the water

Nut

 

pipe, insert the water pipe to the refrigerator

 

inlet valve by pressing downwards firmly.

 

2. Fix nut as seen in the opposite figure, by

2

squeezing by hand on the refrigerator inlet

 

valve.

1

Note: You should not need to tighten the

 

nut with a tool to achieve water tight

 

assembly. In case of a leak use a spanner

 

or a pair of pliers to tighten the nut.

Valve

 

10

EN

Page 10 Page 12
Image 11
Page 10 Page 12
Contents NF1 Contents Refrigerator Rear Cover Never Remove this Cover Model NF1 Technical specifications of your refrigeratorPrior to operating your refrigerator Why No-Frost?Safety precautions 74 cm 117 cm 92.5 154 cm Placing and Assembly of Your RefrigeratorUsage area measures Below. Ensure that door shelves are Floor balance adjustment Door height adjustmentFigure C Connection of the Water Pipe to Refrigerator Installation RequirementsConnection to the Cold Mains Separate the nut from the tap adaptor Connection of the Water Pipe to the Cold Water Mains LineIs active before taking out the by-pass cover To exit from this modeWater Filter To fit the water filter follow the instructionsYour device to the water mains, make sure Water ReservoirIce/Water Dispenser Prior to First Use For 2 seconds and the warning will be reactivatedOperating your refrigerator Water Dispenser Lights Using your refrigeratorSetting Buttons and Temperature Control Fresh Freeze Function Making the Fridge Compartment Temperature AdjustmentMaking the Freezer Compartment Temperature Adjustment SET Special Economy Function Auto Eco Water/Ice Type Selection Dispenser ModeQuick Cool Function Vacation ButtonIce/Water Dispenser Using the accessoriesUsing the Water Dispenser Using the Ice DispenserPull Cleaning the Icebox and the Water DispenserLift Ioniser Humidity control in the crisperSliding Shelves Snack TrayCrisper and Chiller Compartment Fresh FreezeRecommendation for Preservation of Frozen Food Freezing Fresh FoodReplacing the Interior Light Bulb 24 EN Placing the foodDeep-Freeze information Things to be done for saving energyWe recommend that you Cleaning your refrigeratorThings to be done before calling the authorized service Freezing of the food Complaint Possible Reason Solution Noise Operation noise increases Drawers are stuck 31 EN Page 48 4501
Top Page Image Contents