Turning on the Appliance, Re-Lighting | Teka Gas Hobs CGX 60 4G IS

fig. 6

Indicator of the burner being used

Off position

Maximum gas position

Minimum gas position

TURNING ON THE APPLIANCE

Whenever you connect the hob to the electrical mains for the first time, the lock function will be activated. To deactivate this function, see the section "Locking the hob sensor".

1 Touch the on sensor button (1) for at least one second.

The next action must be taken within three minutes; otherwise, the touch control panel will automatically turn off.

IGNITING THE BURNERS

Once the touch control panel has been activated by using the sensor button (1), you can turn on the chosen burners.

To do so, please do as follows (see fig. 6):

1 Make sure that the knobs are in the correct position.

2 Turn on the gas at the mains or turn the gas cylinder tap.

3 Turn and put pressure on the burner knob so that the gas ignites.

4 Place the knob in the desired position.

5 The burner selection light will go on.

The control panel has marked zones (A) that indicate the control knob that corres- ponds to each burner.

Use flat-bottomed cookware and make sure that they sit squarely on the pan sup- port, so that the cookware does not slip when food boils (do not use cookware with a concave or convex base).

If an error occurs while igniting the burner, the burner will be deactiva- ted after the safety time has elapsed (10 seconds).

These hobs may not be lit using matches.

Table with diameters of cook- ware according to the type of burner

Burner	Power	Diameter of
		cookware
	(in Watts)	(in cm)


Triple ring	3500	_
		24 : 26
Fast	3000	_
		20 : 22
Semi-fast	1750	_
		16 : 18
Auxiliary	1000	_
		10 : 14

RE-LIGHTING

If one of the burners accidentally turns off with the tap connected (i.e. turned), the system will automatically attempt to re- light the burner for 10 seconds.