cannot be damaged by accidental blows or heavy weight.
If the glass breaks or cracks, the hob should immediately be disconnec- ted from the electric current in order to avoid the risk of electric shock.
The glues used in manufacturing the kitchen unit and on the decorative laminates and on the laminates that are part of the worktop surface should be made to tolerate temperatures of up to 100ºC.
TEKA does not assume any res- ponsibility for any malfunction or damage caused by faulty installation.
PLEASE REMEMBER THAT THE GUA- RANTEE DOES NOT COVER THE GLASS IF IT SUFFERS A VIOLENT BLOW OR IF IT IS USED IMPROPERLY.
Positioning the oven
Please see the corresponding manual.
Fixing the hob
When the gap has been properly sized, the gasket (A) should be put on the lower side of the hob. Place the clips (D) as indi- cated in figure 2, fastening them to the holes of the lower part of the body by using the
If the thickness of the kitchen unit is equal to or less than 30 mm, use the
GB
fig. 2
20 mm
30 mm
40 mm
Gasket
Hob
Screw
Clip
Note: It is essential that the gasket be placed under the brim of the hob. Failure to install it may cause the work- top to be exposed to high temperatures.
Connecting the gas
The gas exit pipe of the hob should be connected to the gas mains according to installation standards or regulations in force and it should be done by qualified technical staff (an authorised installer). Since it is an immobilised appliance, the gas connection for these hobs must be done using rigid piping for hobs to be used in the EC. The hob comes with a ½" dia- meter threaded connection as per EN ISO
The gas exit pipe of the hob should be connected to the gas mains following basic guidelines for the installation of gas in inhabited buildings
TEKA does not assume any responsibility for any malfunction or damage caused by incorrect or faulty installation.
To avoid damaging the hob when tighte-
7