Emergency SHUT-OFF

The appliance may be turned off at any time by touching the general on/off sensor button (1). After doing so, turn the con- trol knobs back to the initial position.

TURNING OFF THE BURNER

1 Use the corresponding control knob to lower the power to the off position (B in fig. 6).

Once the burner has been turned off, its light (2) will go on, which indicates that there is residual heat, i.e. that it is still hot and, therefore, it may cause burns.

TURNING OFF THE APPLIANCE

1 Once all of the control knobs are in the off position (B in fig. 5), touch the gene- ral on/off sensor button (1)

If the light of a burner (2) (see fig.

5)is flashing, it means that the control knob should be turned again to the off position.

Locking the sensor buttons

of the hob

If the hob is disconnected and you touch the on/off sensor button (1) for more than 4.5 seconds, you will lock the bur- ners. This will allow you to prevent undesi- rable operations from occurring acciden- tally and it will make it so children are not able to manipulate the device. Once the sensor button lock has been activated, the indicator light (5) will turn on.

If you try to light a burner when this func- tion is activated, its light (2) will flash, indi- cating that it is an erroneous operation.

To deactivate the lock function, touch the

on/off sensor button (1) again for at least

4.5seconds. The lock indicator light (5) will turn off, the light (6) will stay on and it will be possible to once again use the control knobs.

The lock only works on the elec- tronic system; it does not affect the mechanical movements of the taps of each burner. This means that, when the lock function is activated, gas will come out when pressing on the control knobs.

Safety disconnection

MAXIMUM OPERATION TIME

If one or more burners are left on, they will disconnect automatically after six hours.

Safety against overheating

The hob is protected against overheating of the electronic system, which could damage it.

The entire hob will turn off if the tempera- ture of the electronic system exceeds 105º C, and it will begin functioning again nor- mally when the temperature decreases to 95º C.

Warnings:

You should periodically clean the ignition unit very carefully (ceramic and electrode) in order to prevent ignition problems. Also make sure that the ope- nings of the burners are not obstruc- ted.

When the burners are being used or have recently been used, some areas of the hob will be hot and can burn. Children should be kept well away.