Index | Instructions for use |
Cleaning and maintenance | Activated charcoal filter |
GB
Description of the appliance | Page 16 |
|
|
Instructions for use | 16 |
|
|
Cleaning and maintenance | 17 |
|
|
Technical Information | 17 |
|
|
Installation | 18 |
|
|
If something does not work | 18 |
Description of the appliance
AMotor controls that allow three speeds to be selected
BLight switch independent of the motors
CLighting by means of lamps
DFilters located over cooking area, easi- ly withdrawn for cleaning
E
FPossibility of incorporating activated charcoal filter
GMotor functioning indicator light
A 
B 
G
E
C | D |
| |
| H |
| I |
F |
|
The hood may have two types of switches according to the model:
By pressing the button shown in the fig- ure, you will be able to control the func- tions of the extractor.
Switch on
Switch off
Switch on
Switch off
Speed Light
o Stop | Switch on/off |
ILow II High
+ Intensive
To achieve better extraction, we recom- mend switching on the extractor a few minutes before starting to cook (3 - 5 minutes) so that the air flow is continu- ous and stable when extracting the fumes.
Likewise, keep the extractor switched on for a few minutes when cooking is com- plete to allow all fumes and odours to be expelled.
Before carrying out any cleaning or main- tenance activities, ensure that the extrac- tor is disconnected from the mains.
To carry out cleaning and maintenance, follow the safety instructions indicated on Page 15.
Filter cleaning
To withdraw the filters from their loca- tions release the anchoring points. Clean the filter, either by putting it in the dish- washer (see notes) or leaving it standing in hot water to simplify the removal of grease or, if wished, by means of special sprays (protecting the non metallic parts). Once clean, leave it to dry.
Notes: cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts, without this affecting its gas retaining properties.
N.B. The filter must be cleaned at least once a month depending on how often the extractor is used. It must be remem- bered that grease is deposited in the extractor when cooking, whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water is recommended. A cloth moistened in this water is used for cleaning the extrac- tor, paying special attention to the grids. Afterwards, dry using a
Note: Never use metallic scouring pads or abrasive products that could damage the surface.
Do not use scrapers with metallic sur- faces such as knives, scissors etc.
To install the charcoal filter, disassemble the lid, locate the filter in the position provided and reassemble the lid.
The carbon filter lasts from three to six months depending on the particular con- ditions of use.
The activated carbon filter can neither be washed nor regenerated. Once it is exhausted, it must be changed.
To replace exhausted filters with new ones, withdraw the old one in the reverse order to that of installation.
Changing Bulbs
Remove the filter support to acces the bulbs. Take care to disconnect the hood from the mains beforehand and that the bulbs to be replaced are not hot.
The maximum bulb power is 40 W.
Technical information
Dimensions | Width = 600 mm |
| Depth = 500 mm |
| Height = 150 mm |
Electrical characteristics
REFER TO RATING PLATE
600 |
150 |
500 |
Made in European Community - C.I.F.:
Mod. | XXX – ZZ |
| N.º de fábric. |
|
| |
|
|
|
| |||
Typ. |
| Serial No. |
|
|
| |
POTENCIA NOM. LAMPARAS |
|
| ELECT. | |||
NENNLEISTUNG GLÜHLAMPEN |
| 000…000 V. ~ | ||||
LAMPS RATE |
|
| ||||
| 2x40 W | 00 Hz | ||||
PUISSANCE LAMPES |
| |||||
| 000 W. | |||||
POTENCIA NOM. DAS LAMPADAS |
| |||||
|
|
| ||||
GB