Installation

To fix the extractor to the kitchen unit the pattern on page 18 is used.

The lower part of the extractor must be located at a minimum height of 60 cm above the hob for electric cookers and 65 cm for gas cookers. If the instructions of a gas cooker indicate a greater distance these must be observed.

The extractor must be connected to a wall socket with an effective earth. When the extractor is working at the same time as other non-electrical cook- ing equipment, the outlet air pressure must not exceed 4 Pa (4 x 10-5bar).

To achieve optimum performance the length of the outlet hose should not exceed 4 meters, or include more than two 90º angles (elbows).

Although venting to the outside is recom- mended, activated carbon filters may be used, which allow the gas to be returned to the kitchen through the outlet pipe.To evacu- ate via the upper part, an external evacua- tion conduit is needed and the evacuation

lever to be located in the “E” position. The small (anti-return) outlet hose is located, ensuring that the remaining outlets are duly plugged. To allow re-circulation through the active carbon the evacuation lever is located in the “I” position, ensuring that the upper opening is plugged. Then the activated car- bon filter is located in the inlet mouth.

If something does not work

Before seeking technical assistance car- ry out the following checks first:

Special U.K. Requirements

Height above gas hob: 75 mm minimum

NEVER PLACE THE COOKER HOOD OVER AN EYE-LEVEL GRILL.

This appliance must be connected by a competent person, using fixed wiring via a DOUBLE POLE SWITCHED FUSED

SPUR OUTLET.

Electrical connection

We recommend that the appliance is con- nected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. Should the colour of the wires in the mains lead for the appliance not correspond with the coloured markings identifying the termi- nal in your spur box proceed as follows:

-The wire which is coloured blur must be connected to the marked N (Neutral) or coloured Black.

-The wire which is coloured brown must be connected to the marked L (Live) or couloured Red.

-Where avialable (see installation), the wire

which is coloured yellow/green must be

connected to the market or coloured Yellow/Green.

If the cooker hood is installed for use above a gas appliance then the provision for venti- lation must be in accordance with the Gas Safety (Installation & Use) Regulations 1984 and the relevant Building Regula- tions. Detailed recommendations are con- tained in the following British Standard Codes of Practice BS6172, BS5440 and BS6891 Current Edition.

Defect	Possible cause	Solution

The extractor	The cable is not connected	Connect the mains cable
does not work
does not work	No current is reaching the plug	Revise/repair the
		electricity circuit
The extractor does not	Filter saturated with grease	Clean or substitute filter
blow enough or vibrates	Outlet obstructed	Eliminate obstructions
	Inadequate air conduit	Contact the installer and follow
		instructions of this manual
The lamps do not light	Lamp broken	Exchange the bulb
	Lamp loose	Tighten bulb

TEKA INDUSTRIAL, S.A. reserves the right to make corrections in its appliances wher- ever it considers these necessary or useful, without harming their essential features.