![](/images/new-backgrounds/1034547/3454717x1.webp)
Connect and Configure Your Desk Phone
There are three setup options for connecting the CS510/CS520 to your desk phone. Select one of the following and continue.
•Desk phone (standard)
•Desk phone + HL10 lifter (sold separately)
•Desk phone + EHS cable (sold separately)
NOTE If you will be using a standard desk phone set up or a desk phone with an HL10 lifter, continue below. If you will be using the desk phone with an EHS cable, refer to Desk phone plus EHS cable section in this guide. For further installation information refer to the EHS Getting Started guide that came with your EHS cable or at plantronics.com/accessories.
Desk Phone (standard)
1Connect one end of the telephone interface cable to the back of the base.
2Disconnect the handset coil cord from the desk phone and
3Connect the remaining end of the telephone interface cable into the open handset port on the desk phone.
NOTE Your desk phone handset will continue to work; it’s just hooked up differently.
USE
NOTE If your phone has a
9