Maytag HE21282T, HE31250T, HE31250S Installation Instructions, Removing the Old Water Heater

Page 7

Installation Instructions

Removing the Old Water Heater

Turn "OFF" electrical supply to the water heater.

@__

@Turn "OFF" the water supply to the water heater a the water shutoff valve or water meter.

(_ a. If you have copper piping tO the water heater, the two copper water pipes can be cut with a hacksaw approxi-

the water heater. This will avoid cutting off the pipes too short. Additional cuts can be made later if neces-

sary. Disconnect the temperature-pressure relief valve drain line. When the water heater is drained, discon- nect the hose from the drain valve. Close the drain

valve. The water heater is now completely disconnect-

ed and ready to be removed.

mately four inches away from where they connect to

, ]_ @

_,_= I ]

Attach a hose to the water heater drain

 

valve

and put the

other end

in

a floor

_[_-- --- I_

heater drain valve. Open a nearby hot

 

water faucet which will relieve pressure

U

drain

or outdoors.

Open

the

water

in the water heater and speed draining,

__

II'- - [[

valve may be extremely hot. To avoid being scalded, make sure all connections are tight and that the

water flow is directed away from any person.

Check again to make sure the electrical supply is turned "OFF" to the water heater. Then disconnect the electri-

The water _'passingWARNINGoutof the drain __1 t1__ cal supply connection from the water heater junction

('_)b.

_

If you have galvanized pipe to the water

with a pipe wrench at the union in each lineheater. Also, loosendisconnectthe twothegalvanizedpiping remainpipes- ing to the water heater. These pieces should be saved since they may be needed

Disconnect the temperature-pressure relief valve drain line. When the water

heater is drained, disconnect the hose from the drain valve. Close the drain

valve. The water heater is now completely when reconnecting the new water heater.

disconnected and ready to be removed.

,_

box.

Mineral buildup or sediment may have accumulated ] in the old water heater. This causes the water /

__1_._

residue, if spilled out,

could cause staining.

and this

]

heater to be much

heavier than normal

 

7

Image 7
Contents Voltage certificationno gr MaagAwarning Safety InstructionsDEATH, Serious Bodily INJURY, or Property Damage AwarningiWater Heatersor ONE Voltage Safety Instructions contdTable of Contents Customer Information Product SpecificationsAdditional Tools Needed Accessories and Tools NeededAccessories When Sweat SolderingRemoving the Old Water Heater Installation InstructionsInstructions for Installation contd OUS Bodily INJURY, or Property Damage Convertible Lower ElementWater Piping Aboovef AndltcodereorementsofASMECoupling Asshownnippl,a ecouplinga d mustbeusedBussbar Instructions for Installation contdEsult in D Eath Seri OUS B Odily Injury , or Property Damage Converting the Lower Element contdOUS BOD LY NJURY, or Property Damage Or Property DamageNever use this Water heater unless It is completely = eJ Wiring Diagrams OELE R ,CConduit WiringReliei ColdConduit PRE!URE=mt,=raLure eL,nus Service and MaintenanceUpper Thermostat Adjustable Behind Upper Access Panel ThermostatsDischargepipe Awarning Service and Maintenance contdThermostat Adjustments Valve OperationDEATH, Serious Bodily INJURY, or Property Nep,acementDirected away from any person Element CleaningReplacement contd Water passing out of the drain valve may beService and Maintenance contd Drain Valve Washer ServiceDEATH, Seri OUS B Odily INJURY, or PR Operty Rumbling Noise TroubleshootingStart Up Conditions Thermal ExpansionWater is TOO HOT RESETBuI-rONLY INJURY, or Property Damage IiNever use this watssACAUTION it is completelyRepair Parts List Gallon Repair Parts List contdSee N OTE on Model NumbersOdel Numbers KEY Part Description NumbersMAYrAG Electricwater Heaters See Note on Gall O NGall on Model Numbers KEY Part Descripti on Numbers66001088 Warranty