Maytag HE31250S Cold, Conduit, Pre!Ure, Reliei, Discharg, FL OOR Drain, Model Rating Plate

Instructions for Installation (cont'd)

Installation Checklist

1. Whether or not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,			HOT ___._[_		_	COLD
check the appropriate	block within the model rating plate,		.
which is located adjacent to the lower access panel.
2. Is the fuse or circuit breaker size correct as shown in the
chart in the "Product Specifications"		section?
			CONDUIT _	v	J_
3. Are the wires from the circuit breaker		or fuse service to the		_		TEMPERATURE-
water heater's junction	box on the correct wire size (gauge) as			_	J	PRE!;URE
						RELIEI
shown in the chart in the "Product Specifications" section?					/q
4. Is the new temperature-pressure relief valve properly
installed, and piped to an adequate drain? See
"Temperature-Pressure	Refief Valve" in the "Instructions				--DISCHARG
for Installation" section,						(Donot c Ip or
						plug

5.Is the water heater completely fdled with water? See "Filling the Water Heater" instructions in the "Instructions for Installation" section.

6.	Will a water	leak damage anything? See "Locating the		/
	New Water	Heater" in the	"Instructions for Installation"	[		- ['-'-
	section.				_	6" AIRG¢
						i r
7.	Are the cold and hot water		fines connected to the water	x_ _"	_
	heater correctly? See "Water Piping" instructions in the			_		FLOORDRAIN
	"Instructions for Installation" section.

8.Is there adequate clearance for maintenance around the water heater?

ELEC'FRICWATERHEATER _o

9. Do you need to call your electric company to check your	m ogwmwcm_	_	(_	Ik1"rAl.LE¢
	,_,,_,_	_
wiring?			I	I
	]	I	I	I

® Maytsgis a Tr=:bonerk of_		Co'potationand
ksusedI_ L_	to S_	Irl_str k_, Inc

MODEL RATING PLATE

17