Maytag mwf4100aws owner manual Choosing a Controller Program, Advanced Controller Model MWF4300AWS

Advanced Controller

(Model MWF4300AWS)

Advanced Controller setup procedure
Advanced Controller				1. Modes: Use ‘next’ button to toggle through modes.
•	Use with waters			2. Manual flush: Press ‘next’ until ‘manual’ is flashing. Press ’manual flush’
	having turbidity up				and hold. If held for longer than 10 seconds, drain valve remains open. Toggle
	to 5.0NTU,				drain valve closed by pressing ‘manual flush’ once.
•	Has two output			3. Setting time of day: Press ‘next’ until ‘set time’ appears. Press ‘enter’. Use
	terminals and				up/down arrows to set time of day. Press ‘enter’ to set.
	controls the			4. Set time of flush: Press ‘next’ until ‘start time’ appears. Press ‘enter’. Use
	automated drain				up/down arrows to set time of flush. Press ‘enter’ to set.
	and inlet valve.			5. Setting program choice: Press ‘next’ until ‘program’ appears. Press ‘enter’.
					Use up/down arrows to select program choice. Press ‘enter’ to set.
					(See Table 6 for programming choices.)
Table 4-Advanced Controller			Setup Procedure
Choosing a Controller Program
						Base Controller
Controller-		Recommended			Source water	Daily household	No.	No.	Flush water used
Program		household			turbidity	water consumption	Flushes	System	per day
		occupancy			(NTU)		per cycle	drains	(flow at
		(persons)						per cycle	7USGAL/min)
Program 1		Up to 4			<0.5	300Usgal/d	2	--	14USgal/d (53L/d)
						(1135L/d)
Program 2		Up to 4			<0.5Peaks to	300Usgal/d	3	--	21USgal/d (80L/d)
					1.0NTU, <5%	(1135L/d)
					of time
Program 3		Up to 6			<0.5 Peaks to	400Usgal/d	4	--	28USgal/d
					1.0NTU, <5%	(1510L/d)			(106L/d)
					of time

Table 5-MWF4100AWS and MWF4200AWS Controller Program Selection

MAYTAG Whole Home Water Filtration System Owners Manual MA1-5

November 2003

23