GE AJHS10DCC installation instructions Storm Window Requirements, Wood Pieces Width 2″

Page 17

Installation Instructions

2STORM WINDOW REQUIREMENTS

A storm window frame will not allow the air conditioner to tilt towards the outside and will keep it from draining properly. To adjust for this, attach a piece of wood to the stool.

WOOD PIECES:

WIDTH: 2″

LENGTH: Long enough to fit inside the window frame.

THICKNESS: To determine the thickness, place a

1/2″ higher than frame

Storm window frame

Wood

Stool

piece of wood on the stool to make it 1/2″ higher than the top of the storm window frame.

Attach securely with nails or screws provided by the installer.

3REMOVE AIR CONDITIONER FROM CASE

ARemove the front grille. See the Care and Cleaning section.

BFind the locking plate located on the front left side.

CRemove the screw and the locking plate to unlock the air conditioner.

Locking plate

Remove screw

DRemove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case.

Remove screw

EPull the bottom corners of the air conditioner and slide it out of the case.

FRemove all shipping pads (if present) inside the air conditioner next to the compressor.

Remove shipping pads (if present)

GRemove the rear grille that is taped to the back of the case. Remove the packet of screws taped to the back of the grille. While holding the grille at a 45° angle, insert it into the clips at the top of the case and push the bottom in. Keep slight upward pressure on the grille until it fits flush with the bottom of the case.

If attaching the grille

 

If attaching the grille

from the outside of

 

on the inside of the

the case use the 2

 

case use the 2 short

long screws.

 

screws.

 

 

 

Clips

Insert the 2 long screws on

Insert the 2 short screws

the outside

on the inside

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Serial # Write the model and serial numbers hereContact a qualified service technician Troubleshooting Tips Consumer Support Cleaning Installation InstructionsOperating Instructions Ge.comInstructions Consumer Remote ControlFan Switch SafetyTroubleshooting Tips Air Direction Vent ControlDown Auxiliary Controls Temperature LimitingGe.com Cooling/Heating Descriptions Mode ControlHeat Pump Models Temp ControlTo reach the fan switches remove the front grille Temperature LimitingCleaning Installation Cleaning Operating Instructions Safety Instructions Care and cleaning of the air conditionerGrille and Case Outdoor CoilsAir Filter How to Insert the BatteriesModel Qualifying Questions Before YOU BeginElectrical Requirements GE KIT Numbers Tools YOU MAY NeedAttach Front Grille Installing a J-MODEL in AN Existing Wall CaseSupport Requirements for AIR Conditioner Installing Through the WallPrepare Opening in Wall Window Requirements Window INSTALLATION-OPTIONALWood Pieces Width 2″ Storm Window RequirementsPrepare Window Install Sill SupportsRight Left MEASURE, CUT and Install Filler PanelsInstall Case in Window Replace AIR Conditioner in Case Install Window Gasket and Locking BracketNormal Operating Sounds Before you call for service…What GE Will Not Cover Air Conditioner WarrantyGE Will Replace Parts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design StudioGrille frontale Instructions d’installationManuel d’utilisation et Avertissement Et nettoyage Instructions de montage En cas de AvertissementTélécommande En cas de panne Soutien au Direction de l’air Commande d’éventInterrupteur du ventilateur Commandes auxiliaires-Limitation de température Commande de la température Commande du modeModèles dotés de boutons de réglage Modèles avec pompe à chaleurLimitation de la température De sécuritéDirection de la sortie d’air Montage Entretien etGrille et boîtier Entretien et nettoyage du conditionneurSerpentins extérieurs Grille frontaleComment insérer les piles Mise EN Garde Ne faitesFiltre à air Exigences EN Matière ’ALIMENTATION Électrique Avant DE CommencerNuméros DE Trousses GE Outils Dont Vous Pouvez Avoir Besoin’AIDE D’UNE Agrafe Retirez LA Plaque DE Verrouillage SUR LE Côté Gauche AvantFixez LA Grille Frontale Glissez Délicatement LE Conditionneur Dans LE LogementSupport DU Conditionneur Installation À Travers LE MURPréparation DE L’OUVERTURE Dans LE MUR Instructions Relatives À LA Fenêtre Installation DE Fenêtre EN OptionRetirez LE Conditionneur DE SON Logement Instructions Relatives À LA CONTRE-FENÊTREPréparez LA Fenêtre Installez LES Supports DE SeuilMESUREZ, Coupez ET Installez LES Panneaux DE Fermeture Montez LE Logement Dans LA Fenêtre Replacez LE Conditionneur Dans SON Logement Bruits normaux de fonctionnement Entretien et nettoyage En cas de panneInstructions de sécurité Nous remplacerons Garantie du conditionneur d’airCe qui n’est pas couvert Et nettoyage Instructions de montage EnSoutien au consommateur Service de réparationsAcondicionador de aire Cuidado y limpieza Seguridad¡ADVERTENCIA Limpieza Instalación Solucionar problemasControl remoto Control remotoLimpieza Modo FAN Ventilador Interruptor del ventiladorControl del escape Dirección del aireDown Controles auxiliares-Limitación de temperaturaNotas Control de la temperatura Descripciones de enfriamientoModelos con bomba de calor Para calefacción máxima SeleccioneDependiendo Del modelo Límite de la temperaturaRejilla y caja Cuidado y limpieza del acondicionador de aireBobinas exteriores Rejilla delanteraCómo insertar las baterías Precaución No opere elFiltro de aire Requisitos Eléctricos Antes DE IniciarNúmeros DE KIT DE GE Herramientas QUE Podría NecesitarUNA LA Rejilla Delantera Cómo Instalar UN Modelo J EN UNA Caja DE Pared ExistentePrepare LA Abertura DE LA Pared Cómo Instalar a Través DE LA ParedRequisitos Para EL Apoyo DEL Acondicionador DE Aire Requisitos DE Apoyo Para EL Acondicionador DE AireRequisitos Para LA Ventana Instalación DE VENTANA-OPCIONALRetire EL Acondicionador DE Aire DE LA Caja Requisitos DE Ventana Para TormentaInstale LOS Soportes DE LA Alfajía Exterior Prepare LA VentanaCentro MIDA, Corte E Instale LOS Paneles DE RellenoInstale LA Caja EN LA Ventana Reemplace EL Acondicionador DE Aire EN LA Caja Instale EL Empaque Para LA Ventana Y EL Soporte DE BloqueoAntes de llamar para solicitar servicio… Sonidos de operación normales Operación Seguridad Solucionar problemas Notas Garantía de su acondicionador de aire Solucionar problemas Apoyo al consumidorGE reemplazará Lo que no está cubiertoSolicite una reparación Apoyo al consumidor Página Web de GE AppliancesGarantías ampliadas Piezas y accesorios

AJHS10DCC specifications

The GE AJHS10DCC is a cutting-edge window air conditioning unit designed to provide efficient cooling solutions for residential spaces. With a compact design and a range of features, it is well-suited for both small and medium-sized rooms, ensuring comfort during the hot summer months.

One of the standout features of the GE AJHS10DCC is its cooling capacity. With a powerful 10,000 BTU rating, this unit can effectively cool spaces up to approximately 450 square feet, making it ideal for living rooms, bedrooms, or even office spaces. Additionally, the unit operates quietly, allowing users to enjoy a comfortable environment without disruptive noise levels.

The GE AJHS10DCC also incorporates a user-friendly digital thermostat with a remote control, providing convenience and flexibility. Users can easily adjust settings from a distance, which is particularly useful when relaxing on the couch or in bed. The programmable timer feature further enhances user experience, enabling the air conditioner to turn on or off at pre-set times, helping to save energy and reduce utility bills.

Energy efficiency is another key characteristic of the GE AJHS10DCC. It is ENERGY STAR certified, which means it meets strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only contributes to lower electricity bills but also aligns with eco-friendly practices, making it a responsible choice for consumers concerned about their environmental impact.

The unit features multiple cooling and fan speeds, along with an energy-saver mode. This allows users to customize their cooling experience based on personal preferences or room conditions. Additionally, the adjustable air vents enable better airflow distribution, ensuring that every corner of the room gets adequate cooling.

Installation of the GE AJHS10DCC is straightforward, thanks to the included mounting accessories. It's designed to fit most standard window sizes, and its lightweight construction makes it easy to handle. Moreover, the unit comes equipped with a washable filter, promoting cleaner indoor air quality by capturing dust and allergens, which can be easily maintained for optimal performance.

Overall, the GE AJHS10DCC combines powerful cooling capabilities with energy efficiency and user-friendly features, making it a top choice for anyone looking to enhance their indoor comfort during the warmer months.
Top Page Image Contents