VOLUME
Cassette Tape Play
[1]Press [< DECK] to open the deck.
(The unit comes on.)
Load a cassette and close the | A |
deck by hand. |
|
A: Side to be played back facing |
|
up. |
|
B: Insert the cassette with the |
|
exposed tape facing you. | B |
[2]Press [1TAPE] to start play.
[3]Press [+, – VOLUME] to adjust volume.
To | Operations |
stop play | Press [∫ TAPE/CD]. |
start one touch play* | Press [1TAPE] when a cassette is |
| loaded. |
TAPE ⁄ CD
R E W 
Volume and sound quality in recording
≥Recording level is set automatically.
≥Recordings are unaffected by changes to sound quality.
To display the tape counter while recording
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
n ,Present state # Present time # Tape counter ]
] ===============n
To reset the tape counter
Press [C.RESET].
The counter resets to “000”.
Erasure prevention
The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown.
Press [5/+/FF]. On remote | |
| control, press [5/FF]. |
|
|
rewind | Press |
| On remote control, press |
| [6/REW]. |
|
|
* when using AC power. |
|
A 
BC A 
D
A Side A
BTab for side “B” C Tab for side “A” D Adhesive tape
Cassette Tape Recording
Before Recording
Your attention is drawn to the fact that recording
Notes:
≥Use household AC power or new batteries when recording to avoid poor recordings caused by the batteries running down.
≥Televisions can cause interference to recordings made on this unit if they are too close to each other.
Selection of tapes
Use normal position tapes.
High position and metal position tapes can be played, but the unit will not be able to record or erase correctly.
10
RQT7912
To erase recordings
1Press [< DECK] to open the deck and insert the cassette with the side to be erased facing up.
2Press [∫ TAPE/CD] to switch to TAPE mode.
3 Press [¥/;].
Recording CDs
Normal recording
Preparation:
Wind on the leader tape.
[1]Press [< DECK] to open the deck.
[2]Press [∫ TAPE/CD] to switch to CD mode.
[3]Press [¥/;] to start recording.
CD play and recording start at the same time. The cassette stops when the CD finishes.