
ge.com
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Safety
COOL Mode
Use the COOL mode with HIGH (F3), MED (F2) or LOW (F1) fan for cooling. Use the Increase ▲ / Decrease ▼ pads to set the desired temperature between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a COOL setting or if turned from a fan setting to a COOL setting, it will take approximately
3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
For Maximum
For Quieter & Nighttime
temperature.
NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting.
Instructions Operating Instructions
FAN Mode
Use the FAN at HIGH (F3), MED (F2) or LOW (F1) to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Air Direction—Side-to-Side
The
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers adjusts the air direction up or down.
NOTE: For best cooling efficiency, angle the louvers up.
5
Installation Instructions Troubleshooting Tips Consumer Support