Installation Instructions
5INSTALL THE SUPPORT BRACKET
ADepending on the slant and depth of your window sill, choose either the short or long leveling bolt and thread it through the appropriate hole in the bottom of the support bracket.
Choose |
|
appropriate |
|
hole to |
|
match sill | Sill |
Choose
either the 
Stool short or long
leveling bolt
BPlace the support bracket on the sill,
against the back edge of the stool, with
its 3 holes positioned on the 1″ line. Loosely attach the support bracket with two Type A screws.
Loosely attach the support bracket with two Type A screws
Sill
Stool
Position 3 holes over the 1″ line
CAdjust the leveling bolt in the support bracket so that it is installed with a slight tilt to the outside. Use a level; about 1/3 bubble will be the correct slant to the outside. Tighten the Type A screws.
Tighten Type | Support | |
A screws | bracket | |
Stool | About 1/3 | |
bubble | ||
| ||
| Adjust | |
| leveling bolt |
INSIDEOUTSIDE
6INSTALL THE AIR CONDITIONER IN THE WINDOW
CAUTION: Do not release grip on the air conditioner until this step is complete with the unit secured in the support bracket and with the window closed in the top channel.
AUsing the hand holds, center the air conditioner in the window with the bottom mounting rail between the window stool and the support bracket trap rail. Close the window into the top channel.
Window |
| Hand hold |
| ||
Top channel |
|
|
Bottom |
|
mounting rail | Support bracket |
| |
Stool | trap rail |
| |
INSIDE | OUTSIDE |
BExtend the accordion panels to fill the window opening and use 4 Type B screws to secure the top and bottom corners.
Install Type B screws
7INSTALL THE WINDOW LOCKING BRACKET AND THE FOAM TOP WINDOW GASKET
A Attach the window locking bracket with a Type B screw.
BCut the foam top
window gasket to the window width.
Stuff the foam between the glass and the window to prevent air and insects from getting into the room.
10