Heath Zenith 7001 manual Battery Replacement, Specifications

BATTERY REPLACEMENT

This solar light contains a rechargeable battery that can be replaced if needed. To replace the battery follow the steps below.

IMPORTANT: The sealed lead-acid battery must be recycled or disposed of properly.

1.Remove rear battery cover. Press in the two catch releases on the cover and remove the cover.

2.Remove rechargeable battery.Slide battery out of case and remove the wire connectors from the battery.

3.Replace battery. Connect the RED wire connector to the positive (+) terminal and the BLACK wire connector to the negative (-) terminal.

4.Replace battery cover.Insert the two tabs on the cover into the slots on the back of the case. Press the cover against the case until the two catch releases snap into place.

IMPORTANT: Keep sensor switch in the “OFF” position for three days to allow the battery to fully charge before testing.

Tab Slots

Positive Wire

Rechargeable

Battery

Battery

Cover

SPECIFICATIONS

Range	Up to 70 ft. (21 m); [varies with
	surrounding temperature]
Sensing Angle	Up to 180°
Lamp	15 watt, 6 volt halogen
Battery Type	Sealed lead acid, 6 V 6.0 A-Hr.
On Time	1 or 5 minutes, re-triggerable
Full Charge on Time	Up to 1 hour

IMPORTANT:Replace lamp only with same type lamp, 20 watts or less. DO NOT reverse the battery wires. Damage to the unit will result. Like any lead-acid battery, this battery must be disposed of properly.

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

Negative Wire

Battery Cover Catch Release

598-1305-02