Heath Zenith 7001 manual Model, Features, Requirements, Unpacking, Installation

Solar Powered Motion Sensor Light

Model 7001

Features

•Turns on light when motion is detected.

•Automatically turns light off.

•Photocell keeps the light off during daylight hours.

•Battery Protection Circuitry. Unit will shut down when battery is low. Unit will automatically resume operation when battery is recharged to a safe level.

Requirements

•Do not turn the light on before the battery is fully charged. Charge the battery by keeping the switch in the OFF position. Plug the solar panel cable into the bottom of the battery case. Point the solar panel directly at the noon sun for 3 sunny days. If not fully charged, the unit will not work.

•When FULLY charged, the solar light will operate a maximum of 15 days without sunlight. Actual operating time will vary depending upon how frequently the light is triggered.

Unpacking

Be sure to remove all contents from packaging and verify all items are present before assembling this light fixture. This package includes the following items:

INSTALLATION

For best performance, mount the fixture about 8 feet (2.4 m) above the ground.

Mounting Holes (3)

Three Mounting Holes for Solar Panel Base

1.Mount solar panel base on a solid surface using three tapered screws. Adjust the panel to point directly at the noon sun. Avoid obstructions such as trees or buildings that may block sun light. Allow for enough wire to reach the case. Keep ball joint at bottom.

Note: You will want to re-aim the solar panel as the seasons change to keep it pointed directly at the noon sun.

6 3/4"	Mounting
	Holes (2)

2.Mount the battery case on a solid surface using two round-head screws and the keyholes on the back of the case.

3.Adjust sensor. For proper operation, the sensor head must be rotated so that the sensor controls face downward as shown below.

IMPORTANT: The controls must face downward to avoid damage from rain. If controls face upward, move sensor to the original down position, rotate 180°, then raise to the position shown below.

1. Solar Light Fixture 2. Solar Panel

Battery

Case

Light

Sensor

Light Joint Clamps

Battery Case

Sensor

Sensor Joint

Clamp

Light

Lense Removal Tab

3. Mounting Screws (2 sizes)

Tapered Screw (3) Round Head Screw (2)

© 2008 HeathCo LLC

Controls

4.Plug the solar panel cable into the bottom of the battery case. IMPORTANT: Allow the battery to charge with three days of sunshine before testing.

598-1305-02