❐Radio
Trouble
Much noise in FM stereo and monaural broad- casts.
Preset station is reset.
Check point
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
The radio antenna is not extended enough.
aExtend fully the radio antenna.
Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always active.
❐CD
Trouble
Disc is in the CD compartment but no sound is made, or disc is ejected automatically.
Sound skips, bad sound quality. (e.g. caused by noise)
Sound skips due to vibration.
Check point
Disc is upside down.
aPlace disc in the correct direction with the label side up.
•Disc is dirty.
•Disc has scratches.
aClean disc, referring to the section on “Notes on Discs”.
A disc that has data other than
aDiscs that have CD-DA type data should be used.
aThe unit may not successfully playback a
•Disc is dirty.
•Disc has scratches.
aClean disc, referring to the section on “Notes on Discs”.
aThe unit may not successfully playback a
Mounting angle is over 30˚.
aAdjust mounting angle to less than 30˚.
Instable mounting.
aMount the unit securely with the mounting parts, referring to the section on installation.
19