Troubleshooting
If You Suspect Something Wrong
Check and take steps as described below.
If the described suggestions do not solve the problem, it is recom- mended to take the unit to your nearest authorized Panasonic Servicenter. The product should be serviced only by qualified person- nel. Please refer checking and repair to professionals. Panasonic shall not be liable for any accidents arising out of neglect of checking the unit or your own repair after your checking.
Note: For whatever is printed in italics in “Check point” column, Conduct the operations and checks by yourself.
Warning
¡Do not use the unit in an irregular condition, for example, without sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer.
¡Never try to repair the unit by yourself because it is dangerous to do so.
Trouble | Check point |
Trouble | Check point |
Common
No power
¡ Start the engine. (Or turn the ignition |
switch to the ACC position.) |
¡ Verify the wiring. (Ex. battery lead, |
power lead, ground lead, etc.) |
¡ Fuse blown (Contact the nearest |
Panasonic Servicenter.) |
¡ Ask a professional for fuse replacement. |
¡ Be sure to use the same rated fuse. |
Disc Player
No sound, or disc is automatically ejected
Sound skip, poor sound quality
¡Load the disc correctly.
¡Clean the disc.
¡Clean the disc.
No sound
¡ Disable the mute function. |
¡ Verify the wiring. |
¡ Wait until the dew disappears before |
turning on the unit. |
Sound skip | ¡ The maximum permissible tilt angle is | |
due to | 30°. | |
vibration | ¡ Secure the unit. | |
|
| |
|
| |
Disc not | ¡ Press [u]. If the disc is still not ejected, | |
contact the nearest Panasonic | ||
|
Noise
No sound from
left, right, front, or rear speaker
Left and right
sounds are
reversed
¡Make sure that grounding is established properly.
¡Adjust the balance and fader.
¡Verify the wiring.
¡Connect the speaker lead correctly.
ejectable | Servicenter. |
|
Error Display Messages
(The disc is ejected automatically.) The disc is dirty, or is upside down. The disc has scratches.
¡ Check the disc.
Radio
Frequent
noise
Preset data are deleted
¡Tune into another station of
¡Make sure that the antenna mounted point is grounded properly.
¡The preset memory is cleared to return to the original factory setting when the power connector or battery is discon- nected.
No operation by some cause.
¡If normal operation is not restored, call
the store where you purchased the unit or the nearest Servicenter to ask for repairs.