APC NS1435A manual Installation and Setup, Leveling the enclosure and installing bottom trim

Page 12

Installation

Installation and Setup

If equipment mounting rails are adjusted from their standard factory installed positions to a deeper position, such as in a networking application, the levelling feet must be used.

Note: The bottom trim and leveling feet are packaged separately and placed in the enclosure.

Leveling the enclosure and installing bottom trim

Level the enclosure before installing equipment.

The leveling feet at the corners provide a stable base if the floor is uneven, but they cannot compensate for a badly sloped surface.

1.Move the enclosure to a level location.

2.For each leveling foot turn the leveling foot clockwise to extend the leveling foot until it makes firm contact with the floor.

3.Install the front and side bottom trim.

The enclosure can be leveled after equipment has been installed. Turn the leveling foot clockwise to extend the leveling foot until it makes firm contact with the floor.

ns1456a

Rack stabilization options

Lock the casters for additional stabilization.

ns1590a

8

NetShelter CX Enclosure: Installation and Customization

Image 12
Contents Installation and Customization Page Contents Specifications Important Safety Information General InformationDisclaimer About This ManualRelated Documents User Comments Product Overview DescriptionNetShelter CX Enclosures Product Inventory Enclosure componentsSafety Important InformationTools Configuration Front doors and Side PanelsBlanking panels Removal Installation Installation and SetupLeveling the enclosure and installing bottom trim Rack stabilization optionsRemoving and Installing Fan Modules Unlock the fan moduleLock the fan module Removing the fan moduleSpecifications Rack PDUAP9567 North American AP9568 InternationalAdjusting the vertical mounting flanges on the side braces Vertical Mounting FlangesInstalling Equipment Installing cage nutsIdentifying one U-space on the vertical mounting flange Removing cage nutsEquipment Planning Guidelines Dimensions Enclosure dimensions internalRear cable access port Vertical 0U accessory channelsCable Management Cable management options for 600-mm and 750-mm enclosures SKUNs1156a AR8105BLK Enclosure placement CoolingSpecifications 750-mm, 18, 24, 38-U EnclosuresTwo-Year Factory Warranty Terms of warrantyNon-transferable warranty Exclusions Warranty claims Page APC Worldwide Customer Support 990-3594A-001 08/2012