APC AR4038A, NS1435A manual Important Information, Tools, Safety

Page 9

Important Information

Tools

Other tools required (not provided)

Phillips screwdriver

Utility knife

Level

Cage nut tool

Safety

Important Safety Instructions

Save These Instructions This manual contains important instructions that must be followed during installation, operation, and maintenance of the equipment.

Use caution when moving an empty enclosure on its casters; the enclosure may be unstable when pushed or pulled from the side. Push the enclosure from the front or back when moving it on its casters. For extra stability, load 158 kg (350 lbs) of equipment into the bottom of the enclosure before moving it on its casters.

WARNING

TIPPING HAZARD

Stabilize the enclosure before installing the components.

Do not extend components on sliding rails out from the enclosure until you have installed three or more pieces of similar equipment, or the stabilizer plate or bolt-down brackets are installed.

Do not extend more than one component from the enclosure at a time.

Load the heaviest components first, and place them toward the bottom of the enclosure to prevent the enclosure from becoming top-heavy.

Failure to follow these instructions can result in death, serious injury, or equipment damage.

NOTICE

To ensure adequate air movement, place the side of the enclosure no closer than six to eight inches to the wall.

Moving the enclosure

Casters. The total load on the casters may not exceed 450 kg (992 lbs). See the enclosure “Specifications” on page 20.

The front wheels have 360 degree rotation for maneuverability. Rear wheels have front-to-back motion for stability. Push the enclosure from the front or the back, not the sides; it may be unstable when pushed from the side. For greater stability, load 159 kg (350 lbs) or more of equipment into the enclosure before moving it on its casters.

NetShelter CX Enclosure: Installation and Customization

5

Image 9
Contents Installation and Customization Page Contents Specifications General Information Important Safety InformationDisclaimer About This ManualRelated Documents User Comments Product Overview DescriptionNetShelter CX Enclosures Enclosure components Product InventorySafety Important InformationTools Configuration Front doors and Side PanelsBlanking panels Removal Installation and Setup InstallationLeveling the enclosure and installing bottom trim Rack stabilization optionsUnlock the fan module Removing and Installing Fan ModulesLock the fan module Removing the fan moduleRack PDU SpecificationsAP9567 North American AP9568 InternationalVertical Mounting Flanges Adjusting the vertical mounting flanges on the side bracesInstalling cage nuts Installing EquipmentIdentifying one U-space on the vertical mounting flange Removing cage nutsEquipment Planning Guidelines Enclosure dimensions internal DimensionsRear cable access port Vertical 0U accessory channelsCable Management SKU Cable management options for 600-mm and 750-mm enclosuresNs1156a AR8105BLK Cooling Enclosure placement750-mm, 18, 24, 38-U Enclosures SpecificationsTwo-Year Factory Warranty Terms of warrantyNon-transferable warranty Exclusions Warranty claims Page 990-3594A-001 08/2012 APC Worldwide Customer Support