Pelco IP3701H-2 manual Installation, Lens Mounting, Camera Mounting, Dc Aid Auto Iris Lens

Page 10
Installation

Installation

LENS MOUNTING

The camera can be used with a fixed iris, manual iris, or auto iris lens. The camera is factory set for a CS mount lens, but is easily adjusted for a C mount lens.

1.C mount lens only: Completely rotate the back focus adjustment counterclockwise before installing the C mount lens (refer to Back Focus Adjustment on page 15).

2.Set the lens mode selector switch on the side of the camera to AIV (auto iris video drive) lens or AID (auto iris DC drive) lens. Refer to Switch Settings on page 16. Switch settings are determined by the type of lens used.

3.Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the lens and the CCD element. If necessary, use clean compressed air to remove any foreign matter.

4.Connect the auto iris lens to the 4-pin connector located on the side of the camera. Pin connections for the iris drive connector are as follows:

3

4

PIN

DC (AID) AUTO IRIS LENS

VIDEO (AIV) AUTO IRIS LENS

 

 

 

1

Control coil negative (-)

Lens positive supply

 

 

 

 

2

Control coil positive (+)

Not used

 

 

3

Drive coil positive (+)

Video drive signal

1

2

4

Drive coil negative (-)

Ground

 

 

 

 

 

CAMERA MOUNTING

Use a standard 1/4-20 screw (provided) with a maximum thread length of 3/8-inch (10 mm) for mounting to the top or bottom of the camera.

10

C2941M-C (6/08)

Image 10
Contents C2941M-C6/08 IP3701H-2Series IP Color CameraI N S T A L L A T I O N Page Contents C2941M-C6/08Important Safety Instructions Open Source Software NoticeRegulatory Notices RADIO AND TELEVISION INTERFERENCEDescription MODELSFigure 1. DHCP Network Example Basic System Configurations3rd PARTY RECORDING SOLUTION Figure 2. Endura Network ExampleFigure 4. Static Network Example 3rd PARTY RECORDING SOLUTIONFigure 3. Private Network Example TCP / IP / INTERNETCamera Layout RESET BUTTONUnit Status Indicator Light ModeCAMERA MOUNTING InstallationLENS MOUNTING DC AID AUTO IRIS LENS24 VAC AND BNC CONNECTIONS OPTIONAL Wiring TablesCAT5 CABLE FunctionTotal DIRECT DRIVE DC AUTO IRIS LENS Lens Setup and Focus ProceduresVIDEO DRIVE AUTO IRIS LENS FIXED LENS, NO IRISMANUAL IRIS LENS ZOOM LENSBack Focus Adjustment Figure 7. Back FocusïOptima OPT Switch SettingsìBacklight compensation BLC óAuto iris lens mode selector AIV/AIDtNot Used uExtended dynamic range EDR ~í Automatic white balance AW1/AW2Dynamic Range and EDR C2941M-C6/08Possible Cause TroubleshootingProblem Suggested RemedySuggested Remedy ProblemPossible Cause Image too lightELECTRICAL SpecificationsGENERAL MECHANICALDimensions ENVIRONMENTALPHYSICAL Weight without lensWARRANTY PRODUCT WARRANTY AND RETURN INFORMATIONREVISION HISTORY RETURNSTel 800 Fax 800 International Tel +1 Worldwide Headquarters 3500 Pelco WayClovis, California 93612 USA USA & Canada Fax +1