Pelco IP3701H-2 manual Wiring Tables, CAT5 CABLE, Vac And Bnc Connections Optional, Function

Page 11

Wiring Tables

Wiring Tables

CAT5 CABLE

Connect a Cat5 cable to the RJ-45 network connector. The 8-pin connector includes video and PoE for the camera. PoE (IEEE 802.3af) injects power over the same cabling that carries the network data, eliminating the need for a separate power supply. This simplifies the installation and operation of the camera without any degradation of network performance.

Refer to Table B for pin descriptions.

Table B. Pin Descriptions

Pin	Function
1	TX+
2	TX-	1	8	8
3	RX+				1
				7	1
				8
4	PoE 1-2				6
4	PoE 1-2				4
					5
					3
					2
5	PoE 1-2				1
5	PoE 1-2
6	RX-
7	PoE 3-4

8PoE 3-4

24 VAC AND BNC CONNECTIONS (OPTIONAL)

If PoE is not used, the camera includes a 24 VAC power connector. Connect the power cable to the 2-pin power connector on the back of the camera using the terminal block connector (provided). Refer to Table C for the recommend wire gauge and wiring distances.

The power supply connector is shown in Figure 6. Use only a Class 2 isolated power supply. Refer to Specifications on page 21 for power consumption.

CLASS 2

ISOLATED

POWER

SUPPLY

24 VAC

Figure 6. Power Supply Connections

C2941M-C (6/08)

11

Image 11

Contents I N S T A L L A T I O N IP3701H-2Series IP Color CameraC2941M-C6/08 Page C2941M-C6/08 ContentsOpen Source Software Notice Important Safety InstructionsRADIO AND TELEVISION INTERFERENCE Regulatory NoticesMODELS DescriptionFigure 2. Endura Network Example Basic System Configurations3rd PARTY RECORDING SOLUTION Figure 1. DHCP Network ExampleTCP / IP / INTERNET 3rd PARTY RECORDING SOLUTIONFigure 3. Private Network Example Figure 4. Static Network ExampleMode RESET BUTTONUnit Status Indicator Light Camera LayoutDC AID AUTO IRIS LENS InstallationLENS MOUNTING CAMERA MOUNTINGFunction Wiring TablesCAT5 CABLE 24 VAC AND BNC CONNECTIONS OPTIONALTotal FIXED LENS, NO IRIS Lens Setup and Focus ProceduresVIDEO DRIVE AUTO IRIS LENS DIRECT DRIVE DC AUTO IRIS LENSZOOM LENS MANUAL IRIS LENSFigure 7. Back Focus Back Focus AdjustmentóAuto iris lens mode selector AIV/AID Switch SettingsìBacklight compensation BLC ïOptima OPT~í Automatic white balance AW1/AW2 tNot Used uExtended dynamic range EDRC2941M-C6/08 Dynamic Range and EDRSuggested Remedy TroubleshootingProblem Possible CauseImage too light ProblemPossible Cause Suggested RemedyMECHANICAL SpecificationsGENERAL ELECTRICALWeight without lens ENVIRONMENTALPHYSICAL DimensionsRETURNS PRODUCT WARRANTY AND RETURN INFORMATIONREVISION HISTORY WARRANTYFax +1 Worldwide Headquarters 3500 Pelco WayClovis, California 93612 USA USA & Canada Tel 800 Fax 800 International Tel +1