Panasonic SC-NE5 owner manual Advanced network settings, English

5 Select and input the details.

≥Check your home wireless network name (Network name (SSID)) and password for this network. This can often be found on the wireless network router itself.

[1]Select your home wireless network name.*1

[2]Type the password.

6 Select “JOIN” to apply the settings.

≥In the pop-up screen, select “OK” to continue.

– Select “Cancel” to return to the setup window.

7 The settings are completed when “SUCCESS” is displayed and the Wi-Fi status indicator

stops blinking and lights in blue.

If “FAIL” is displayed press [OK], check the wireless network password and other settings and start again from step 1.

8 Make sure to connect your compatible device

back to your home wireless network.

*1: If you have set your wireless network to be invisible, select “BACK” and refer to “Alternative settings”.

Advanced network settings

≥The below settings are the alternative or additional settings for “Method 4”. (l 12)

Alternative settings

Instead of steps 4 and 5

Select “Manual settings”.

1Type your home wireless network name into the “Network name (SSID)” field.

2Select the encryption method from the “Security system” drop down list.

3Type the password into the “Password” field and then select “JOIN”.

Additional settings

If your home wireless network has been configured to use specific IP Addresses, Subnet Mask, Default Gateway, Primary DNS, etc.

Before step 6

Select “Advanced network settings”.

{.Input the required addresses into each field and select “JOIN”.

≥To change the settings back to DHCP, select “ON” from the “DHCP” drop down list.

If you want to change the name of this system that is displayed as the AirPlay speakers or DLNA renderer.

Before step 4

Select “Additional settings”.

1Select “Edit STEREO SYSTEM name”.

2Type a new name into the “STEREO SYSTEM name” field.

{. Only ASCII characters can be used.

3Select “OK”.

4If this system is already connected to your home wireless network:

jSelect “Additional settings” and then select “Exit”.

If this system is not connected to your home wireless network:

jContinue to step 4 of “Method 4”.

ENGLISH

≥Enable Java and Cookies in your browser settings.

≥This system can also be set using the WPS PIN code. Replace step 2 of “Method 1” with the following steps. (Before starting, refer to the wireless network router’s operating instructions for details on how to enter the PIN code.)

1While “WPS” is flashing press and hold [s WPS] again to display the 8 digit PIN code.

{. Wi-Fi status indicator blinks purple.

2Enter the PIN code into the wireless network router.

13

(ENG) VQT4U55