Panasonic CQ-R223W manual To Remove the Unit, Establish the rear of the unit, Insert Trim Plate

E	Installation (Continued)
N
G
L
I	Cautions:
S
H	• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.

11• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and fingers.

First complete the electrical connections, and	Insert Mounting Collar q into the
then check them for correctness.(a page 25)	dashboard, and bend the mounting
The included Mounting Collar	1 tabs out with a screwdriver.
q is designed specially for this	The tabs to be bent vary depending on the car.
unit. Do not use it to attach any
other model.	To securely install the unit, fully bend a
	number of the tabs so that there is no rattling.
	Example:	Tab

To Remove the Unit

Switch off the power of the unit.

1 Remove the removable face plate.

Press [ ]. (release button). The

removable face plate will be released.

NR	REMOTE	Release button
		MODE
	TUNE

Contact

CQ-R223W

Push

E

N

G

L

I

S

H

12

q Mounting

Collar

Mounting spring (L)

y Power Connector

2 Remove the Trim Plate i with a screwdriver. i Trim Plate

Screwdriver

Mounting Holes t Mounting Bolt

3

Insert the Dismounting Plates u along the grooves on both sides of the main unit until “click” is heard.

Pull out the unit while pushing the plates further inside.

Insert the tab

Insert

u Dismounting Plate

Mounting Springs (R)

Engage Mounting
Springs (C) in the both	Mounting
sides of the mounting
holes of Mounting Collar	Hole

qfirmly.

2

3

4

Establish the rear of the unit.

After fixing Mounting Bolt t connection and Power Connector y, fix the rear of the unit to the car body by either method (a) or (b) shown on the previous page.

Insert Trim Plate i.

After installation reconnect the negative (–) battery terminal.

4

end in the outer groove.

“Click”

Remove the unit pulling with both hands.

Pull out

Mounting Spring

22 CQ-R223W CQ-R223W 23