EN
USAGE INSTRUCTIONS
| DIAGRAM KEY | ||
Base Unit | 12 Headset Docking Cradle | ||
1 | Tx Slide Switch | 13 Charge contacts | |
| (Speak Volume Master) | 14 Charge Indicator | |
2 | Rx Slide Switch | 15 Talk Indicator | |
| (Speak Volume Master) | 16 Power Indicator | |
3 | Speak Volume Adjust UP | ||
17 Handset Lifter (optional) | |||
4 | Speak Volume Adjust | ||
Headset | |||
| DOWN | ||
| 18 Microphone | ||
5 | IntelliStandTM Switch | ||
| ON/OFF | 19 Speaker | |
| 20 Talk Button | ||
6 | Configuration Dial | ||
21 Listen Volume Adjust | |||
7 | AC Power Adapter | ||
UP/DOWN | |||
8 | AC Power Adapter Port | ||
22 Headset Mute Switch | |||
9 | Handset Cable Port | ||
23 | |||
10 Telephone Cable Port | |||
| |||
You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.
Tip: By selecting Handset mode after completing your call, you will conserve the headset battery power and extend the remaining available talktime. You can achieve this by pressing the Talk Button (20) immediately on conclusion of the call.
Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section “Making a call using the Lifter” on page 9.
RECEIVING A CALL USING YOUR HEADSET
When your telephone rings take the handset off the hook. Ensure that your CS50 Wireless Headset System is already in Headset mode. You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.
Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section “Receiving a call using the lifter”
EN
11 Accessory Port
24 Charge contacts
25 Battery Door
on page 9.
ADJUSTMENTS
INSTALLATION
Please install the CS50 Wireless Headset System in accordance with the instructions detailed in the Quick Start Guide.
HEADSET/HANDSET MODE
Pressing the Talk Button (20) on the Headset selects Headset mode. The Talk Indicator (15) on the base unit will illuminate and the
PLACING A CALL USING YOUR HEADSET
To place a call using the headset, the system must be in Headset mode. Take the handset off the hook and dial in the normal way.
PLACING AND RECEIVING A CALL USING THE HANDSET
In Handset mode the telephone can be used to make and receive calls in the normal way.
OUT OF RANGE WARNING
As you walk away from the base unit you will eventually reach the system operating range limit. When in Headset mode a warning alert of two beeps will sound in the headset shortly before you meet the range limit.
On hearing this alert you should walk closer to the base unit to ensure call quality is maintained.
6 | 7 |