American Standard 3801.000, 3841.000 Attach Cable Connector, Check Operation of POP-UP, Cold, Hot

7	ATTACH CABLE CONNECTOR
		Fig. A.		Fig. B.
	Thread CABLE CONNECTOR (1) clockwise
	onto DRAIN BODY CONNECTION (2) and		1
	hand tighten. Fig. A.

Your new POP-UP DRAIN installation is now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

2

1-1/4” O.D.

8 CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and	1
closes.

Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.

2

9 MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED AND MUST BE PURCHASED SEPARATELY.

Thread TEE BODY (4) to SPOUT SHANK (5).

Thread HOSE CONNECTOR (6, 6A) to VALVE CONNECTIONS (7, 7A).

Connect water supply to VALVE BODIES (1,1A) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use

adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing

cutter to cut to proper length.

1A

Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate connectors, and COUPLING NUTS.

Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to

waste outlet. 1

1/2" PIPE THREAD

2

5

7

6

7A

6A

COUPLING

NUT

4

3

3/8 O.D.

BULL-NOSE

RISERS COMPRESSION NUT

FLEXIBLE SUPPLIES

COLD

FERRULE

HOT	3/8 COMPRESSION
	CONNECTION

43167 Rev. 1 . 3

3