![](/images/new-backgrounds/1171339/171339297x1.webp)
MAINTENANCE
Hinge Pins -
Check bolt, nut and collar that fastens hinge pin at rear of unit. See Image
Lift Level Rods
Each level lift rod holds approximately twice the weight of the machine. Careful inspection of each rod and component part is important. Look for excessive wear on the front and rear level lift pins and the drilled holes they ride in. These pins are made of hardened steel and should be replaced only with the proper pins.
Wheel Bearing
The wheel bearings were packed and properly adjusted at the factory. The wheels should be checked each week to see if they need adjustment. Jack the wheel off the ground. Grab the wheel and try to move it in or out. If any movement exists, remove the wheel and inspect the bearings and
FALCON 15/10 03/09 | Maintenance Section |
© 2009 Alamo Group Inc.