ASSEMBLY

ATTACHING CYLINDER HOSES

Attach cylinder hoses to Tractor QD Remotes (Requires Three Spool Tractor Remote Valve to Operate Each Wing and Axle Independently) or use Three Spool Control Valve Option. Proper QD couplers will need to be attached to hydraulic hoses.

Operating Mower Hydraulics with Three Tractor Hydraulic Ports

Connect one hose into each hydraulic port. Connect lines to correspond with position of hydraulic control levers.

Operating Mower Hydraulics with Two Tractor Hydraulic Ports

The lines that operate the wings must be plumbed together and will be controlled using one hydraulic control valve and the center section with the remaining control valve. Ensure that the operator is aware that each wing cannot be controlled independently nor will they raise and lower simultaneously.

ATTACHING ELECTRICAL CONNECTIONS

Attach the free ends of the mower wire harness to a switched power supply of the tractor (Requires 25 Amp Minimum Service). Alamo industrial suggest using the Tractor Auxiliary Power Connector inside the tractor. (If tractor is equipped) The Connector is available from the tractor dealer. If desired, a switch, rated at 25 amp min, can be installed in the power supply line to selectively turn the unit off and on.

LEVELING UNIT

The mower Must Be Leveled after attaching to the tractor. To level the implement correctly refer to Section 7 SETTING THE MOWER of the Operators Section of this manual.

FALCON 15/10 03/09

Assembly Section 3-5

© 2009 Alamo Group Inc.

ASSEMBLY

Page 87
Image 87
Alamo FALCON 15/10 manual Attaching Cylinder Hoses, Attaching Electrical Connections, Leveling Unit