ASSEMBLY

ASSEMBLY

PUMP,SPEED INCREASER AND CUTTER ATTACHMENT

To attach the Speed Increaser, Cutter and Pump to the tractor, use the following procedure:

7.Attach the Speed Increaser Mount Plate to the tractor loosely. Refer to the installation drawing, supplied in the packing box, for specific instructions.

8.Grease the tractor PTO shaft and slide the Speed Increaser on. Install the 1/2" bolts and bushings between the Speed Increaser and Mount Plate. Do not tighten bolts at this time.

9.With the tractor in idle and the PTO engaged, alternate tightening the Mount

Plate bolts following an "X" pattern until they have all been tightened. Refer to Torque Chart for proper torque.

10.Turn off the tractor engine, place the tractor in park, and set the parking brake before dismounting. Then attach the cutter tongue to tractor drawbar with bolt, washers and locknut.

11.Grease the inside and outside of the Splined Adapter Bushing and insert it into the Speed Increaser. Slide the Pump in place and tighten the mounting bolts.

NOTE: When attaching the pump to the speed increaser, reposition the angle of the hose fittings

on the pump to allow sufficient hose movement so that the hoses won’t crimp or twist while in operation.(ex. going through dips and uneven terrain)

Do not operate this Equipment with hydraulic oil or fuel leaking. Oil and fuel are explosive and their presence could present a hazard. Do not check for leaks with your hand! High-pressure oil streams from breaks in the line could penetrate the skin and cause tissue damage including gangrene. To check for a hose leak, SHUT the unit ENGINE OFF and remove all hydraulic pressure. Wear oil impenetrable gloves, safety glasses and use Cardboard to check for evidence of oil leaks. If you suspect a leak, REMOVE the HOSE and have it tested at a Dealer. If oil does penetrate the skin, have the injury treated immediately by a physician knowledgeable and skilled in this procedure. (SG-15)

FALCON 15/10 03/09

Assembly Section 3-4

© 2009 Alamo Group Inc.

Page 86
Image 86
Alamo FALCON 15/10 manual PUMP,SPEED Increaser and Cutter Attachment