American Standard 2071S Test Installed Faucet and Check for Leaks, Adjust HOT Limit Stop

4 TEST INSTALLED FAUCET AND CHECK FOR LEAKS

With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

4a CHECK DRAIN CONNECTIONS

Operate LIFT ROD (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in lavatory. If necessary adjust stopper height by repositioning LIFT ROD (4) and tightening Thumbscrew (6).

Release DRAIN STOPPER (5) and check all drain connections and "P" trap for leaks. Tighten if necessary.

1

3

4

6

5

"P" TRAP

COLD

2

HOT

5 ADJUST HOT LIMIT STOP

By restricting HANDLE rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP (5) reduces risk of accidental scalding. To set the maximum hot water temperature of your faucet, all you need to do is adjust the setting on the HOT LIMIT SAFETY STOP (5).

Remove INDEX BUTTON (1), HANDLE SCREW (2) and pull off HANDLE (3).

Turn CARTRIDGE STEM (4) to the OFF position (coldest setting) before making adjustment to HOT LIMIT STOP (5). Use a flat blade screwdriver to pry free the HOT LIMIT SAFETY STOP (5). Pull upward and rotate counterclockwise one number to limit hot water temperature. Use ARROW (6) on CARTRIDGE (7) and NUMBERS (8) on HOT LIMIT STOP (5) for indication.

Replace HANDLE (3), HANDLE SCREW (2) and INDEX BUTTON (1).

1

HOTTER

(Smaller Numbers)

0 1 3 5 7 9 11 13 15

1

2

3

5

1 513

			9	11
		57			3
	3					1
1
0						5
						1

4

6

8

5

7

FLAT BLADE

SCREWDRIVER 6

1	5	13
			1197531

5

4

1	5	13
			1197531

COLDER

(Larger Numbers)

0 1 3 5 7 9 11 13 15

5

M 9 6 8 2 9 0 A