American Standard 2555.201 Attach Cable Connector, Check Operation of POP-UP, Hot

7 ATTACH CABLE CONNECTOR	Fig. A.	Fig. B.
Thread CABLE CONNECTOR (1) clockwise
onto DRAIN BODY CONNECTION (2) and		1
hand tighten. Fig. A.
Your new POP-UP DRAIN installation is
now complete. Fig. B.
Note: Tailpeice on pop-up drain is 1-1/4” O.D.
Fig. B.
		2
		1-1/4” O.D.
8 CHECK OPERATION OF POP-UP		1
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
closes.

Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.

2

9 MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE PURCHASED SEPARATELY.

Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).

Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.

Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to waste outlet.

1/2" PIPE	1
THREAD
2	COUPLING
	NUT
FLEXIBLE
SUPPLIES
	3
	3/8 O.D.
	BULL-NOSE
	RISERS
3/8” COMPRESSION	COMPRESSION
CONNECTION	NUT
	FERRULE

HOT COLD

M968786 Rev . 1 . 3

3