American Standard 2555.201 POP-UP Drain, Remove Flange, Outlet, Flange Gasket and POP-UP Knob

2 POP-UP DRAIN	Fig. A.	Fig. B.
Remove CLEAR PLASTIC COVER (1).	1
Remove CARDBOARD SPACER (2) from under	3	DRAIN
DRAIN POP-UP (3).
		BODY
Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
	2	4

3 REMOVE FLANGE	Fig. A.		Fig. B.
Thread FLANGE (1) counter-clockwise and remove	1
FLANGE (1) and FOAM GASKET (2) from drain
body. Fig. A.
Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.		2	4
			3

4	INSTALL DRAIN FROM			5 TIGHTEN LOCKNUT
	BELOW FIXTURE		REAR OF SINK
	From under side of SINK			Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up	4		Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty		DRAIN
	or caulk is required.	3	OUTLET
	The CABLE ATTACHMENT
	POINT (2) must face towards
	the rear of the SINK.

Install FOAM GASKET (3) and	1	1
FLANGE (4) onto drain body	2
from above SINK and tighten
FLANGE (4) firmly.

6	FLANGE GASKET AND POP-UP KNOB	Fig. A.	Fig. B.	DOWN
	Check DRAIN FLANGE in SINK to ensure that			1
	WHITE FOAM GASKET (3) is fully compressed
	and not visible. Fig. A.
	POP-UP KNOB (1) must be fully down. Fig. B.	WHITE FOAM
		GASKET	DRAIN
		NOT VISIBLE	FLANGE

M968786 Rev . 1 . 3

2