American Standard 4101.301 installation instructions Install Faucet with Deck Escutcheon

Page 1

 

Installation

 

Instructions

ARCH

4101.301

HI-FLOW KITCHEN FAUCET

 

with SIDE SPRAY

 

Thank you for selecting American-Standard...

the benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin.

4101.301 shown with

4 1 0 1 . 3 0 1

optional escutcheon 4101.000P

Certified to comply with ANSI A112.18.1M

M 9 6 8 5 8 3

RECOMMENDED

TOOLS

Adjustable Wrench

Regular Screwdriver

Phillips Screwdriver

Channel Locks

1

INSTALL FAUCET WITH DECK ESCUTCHEON

(4101.351)

CAUTION

Turn off water at

main supply.

Installation with DECK ESCUTCHEON: Apply a light bead of plumbers putty to underside of ESCUTCHEON (1) if mounting surface is uneven. Place ESCUTCHEON (1) onto sink or mounting surface with large opening to the right as shown. Insert supply HOSES (2) and SHANK (3) through ESCUTCHEON (1) and mounting surface. Make sure slot in fitting base aligns with tab on ESCUTCHEON (1). Figure 1.

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD is centered.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the SCREWS (8) slightly each time until all are snug to ensure even pressure.

Install SPRAY HOLDER: Insert SPRAY HOLDER (11) into ESCUTCHEON (1). From underside of sink or mounting surface thread LOCKNUT (12) onto SPRAY HOLDER (11) shank and tighten.

Install SPOUT ASSEMBLY: Insert SPRAY HOSE (9) and SHANK (10) through ESCUTCHEON (1) and mounting surface. Make sure slot in spout base aligns with tab on ESCUTCHEON (1). Figure 2.

Assemble RUBBER WASHER (4a), BRASS WASHER (5a), and threaded LOCKNUT (6a) onto SHANK (10) from underside of sink or mounting surface. Hand tighten LOCKNUT (6a). Use a screwdriver to tighten SCREWS (8a) on LOCKNUT (6a) the same as fitting installation above.

7

Figure 1

Figure 2

SLOT

 

3

11

1

 

2

ALIGN SLOT AND TAB

TAB

SLOT

ALIGN SLOT

AND TAB10

TAB

 

4

5

1

4a

 

 

 

5a

 

 

6

 

12

 

 

 

6a

 

8

 

 

 

 

 

8a

9

 

 

 

 

 

 

 

 

 

Image 1
Contents 4101.351 Install Faucet with Deck EscutcheonWith soap dish 4101.350 less soap dish Install Faucet Without Escutcheon PlateMake Water Supply Connections ColdCheck Connections for Leaks Connect Spray Hose and Spout HoseService Test Installed FaucetClogged Cartridge outlets or inlets may cause reduced flow HI-FLOW Kitchen Faucet